Creality Official Filament Dryer Box 2.0 with Fans, Upgraded 1KG 3D Printer Material Dehydrator Keep Materials Dry During Printing Storage Drier for PLA PETG ABS TPU Nylon

Works great for me. I can monitor the moisture level and turn on when needed. I also run it when printing for consistency. I use it on my Bambu X1C as the external roll holder for filaments I don’t keep in the AMS. It’s small. Works well, and easy to use. There is a little fan noise but quieter than the 3D printers running beside it.

I bought this off of a recommendation from a lifelong friend. The size is small enough to place almost anywhere, but perfect for your 1kg spools. Dries filament quickly, and the recommended settings for the different filaments is spot on!

This item has been a nice improvement for my Print quality. I had been having issues with bed adhesion and stringing on my prints. The Creality Dryer has performed nicely in the filament performance with my printer. I had better adhesion and less stringing and better prints overall. The little port that allows you feed from the dryer to the printer is a nice feature. It would be nice to have more of them in different places however. Compared to other dryers I had it is a good price for a good product. The unit is slim and fits nicely on a shelf. Over all the product does a good job for the money spent.

Gets up to temp fast and works well, highly recommend to help save some old pla thats turned brittle.

All filament, even fresh out of the bag, has moisture content that's detrimental to print quality. You spent the money for the the printer and filament, get the most out of your investment with a dryer. This is a simple, one bay printer that goes up to 65C for drying PETG and other such filaments. The one knob system is a little quirky. Turn it to select either temperature or duration, press it to enter your selection, turn it to adjust the setting up and down, press again to store. Turn to the other and repeat. There's a hygrometer built in, to keep and eye on it, but its lowest value is 15%. I like to get it down to that and go another couple hours. They give you a reference chart for recommended settings based upon filament.Pro-tip: you need to leave the dryer open a crack so the moisture has somewhere to go. I don't think they really address that anywhere in the papers.

Total game changer for my 3D printing setup! It does a fantastic job of keeping my filament dry, preventing issues like warping or poor adhesion caused by moisture. The built-in fans ensure even drying, and it’s super easy to use. Since I started using it, my prints have been much more consistent and of higher quality. If you’re serious about 3D printing

Good basic dryer. As many other reviews stated, the hygrometer just doesn't work. It pretty much stays at 15% all of the time, but I solved this by adding my own cheap hygrometer/thermometer (about $10 for 6 here on Amazon). Temperature matches the one I set and it gets things dry enough that it gets to the minimum reading of 10% on my hygrometer. Controls are really touchy, but I have been able to make them work. Works fine to feed printer directly from the dryer. Hole in the top allows a Bowden tube to be inserted for feeding the filament. I am satisfied with this purchase but don't count on the built-in hygrometer working.

So far I’ve had no issues. I wanted to wait a few days before posting a review but I’ve ran this for about 30 hours on different petg filament and have not yet had an issue. Time will tell if it holds up. If I have issues in the future I’ll come back and update my review.