[GT-Speed] Compatible/Replacement for Type-R Style PU Front Bumper Lip, 1996-1998 Honda Civic Only (Type-R)

The lines and contours are just right. Even though the reviews were good, I was still skeptical because often times other peoples expectations are not as high as my own. When installing, do yourself a favor and remove the bumper. It makes for a much better installation. Also, make sure you have some quick clamps to lightly clamp the center section to the bumper so you can properly line up the outside edges. When you buy the lip, buy some inexpensive finishing washers and secure the outside edges with those and some bolts. NOT SELF TAPPING SCREWS. Gently tilt the lip up and away from the center section of the bumper (just enough to attach the double sided tape), then press it back down into place against the tape and use the quick clamps to hold it tight for a little while to get a secure bond. I also use the finishing washers in the center section because I think it looks good and gives added security that my lip isn't going to start flopping at high speed.

Super tight fit but fit my 1996 honda civic lx sadan

Fits close enough to the SiR lip. I didn’t want a lip that I needed to drill into my bumper, so chose this brand so I could use the Honda hardware. Mounting can be a little difficult, but just leave it out in the sun for a few hours before install and take it one bolt at a time. Looks great.

Love the look it gives my car. Fits good, the quality is good. For the installation process I remove the front bumper completely for a better and easier installation. Check photos to see end results

The product does not need double sided tape. Installs perfectly without it. I only needed to add 3 extra screws.

Looks great unpainted, but once it does, looks even better

Good quality, but fitment isn’t the best. A bit to short on the ends. I have an OEM bumper.

Came decently packaged but overall a perfect fit on my 98 civic lx