







🧑💻 Elevate your workspace—because your cables deserve a stylish home too!
This 8-pack of 3/4 inch white silicone rubber grommets offers a durable, corrosion-resistant solution for clean and efficient cable management. Designed for easy installation and flexible wire pass-through, these grommets protect cables from sharp edges while enhancing the aesthetic of desks and furniture.
T**S
Works great
Easy to use, flexible to put a usb through for my wyze camera.
T**A
Solid quality grommets
Using these for a DIY project and they work great. Nice quality rubber grommets. What more is there to say? They work as intended to cleanly route cables.
M**R
Perfect way to finish the install
I wall mounted Sonos speakers and fed the power cord thru the wall into an attic power connection. These fit the 1/2 hole perfectly. I did not want big holes so I cut the plug off to feed the wire thru and then wired in a new plug.
B**N
Not terrible, not great
Bought these grommets to hide the wires for our home security cameras (which we really only use to spy on the dogs). Here's what I found:- Measurement is accurate. Fits into 3/4" hole. (I used a 3/4" paddle bit to drill.)- Does not secure in place. The part that fits into the hole is smooth, so there is nothing to grab the drywall and anchor the grommet. If you pull the wire, it will pull the grommet out of the hole. If these are going in a ceiling, you will definitely need glue or they will fall out.- Price point is way too high. These are cheap pieces of molded silicone. Should not cost more than $0.25 each. For the price, I would have expected a more substantial product.- Color is bright white; matches well with white trim/receptacle plates.All in all, they served my purpose. I just wish they had a little more oomph to them for what they cost.
Z**F
These work just great
These grommets form a very neat finish for speaker cabling through the back panel of my desk.Even when the holes that I drilled were a little less than perfect, the grommets confomed to the irregular shape and held neatly onto the back surface. Makes the pass-through cabling look professionally finished despite my very amateur hole drilling!
W**E
Hold charging cables in place.
I drilled 3/4” holes in the surface and inserted these grommets, and they hold my charging cables perfectly in place. No more slipping through the hole under the desk.
J**D
Most Definitely a 5/8" Drill Bit
Go with 5/8" and all good.
D**E
Needed 1/2" size
I needed a 1/2" size for ethernet cable hole in corner of a room. All I found was this 3/4" size which I had to slit and trim to fit. I then secured in place with clear silicone. Looks good. But would have been better with the right size.
Trustpilot
1 week ago
5 days ago