8MILELAKE 1/8"- 7/8" Precision R8 Collets 13pcs Mill Chuck Holder for Bridgeport .0006

I read other reviews about the collets being of different lengths and marking issues. That is true The collets differ in length +or- .1562. The inside depth of the collets are all different and very from 2 inches to all the way to the rod threads. The laser engraved size on the end was almost unreadable. Only one collet was engraved with a little bit of black to be partially readable. The etching on the others were so light unless you knew what to look for you could miss it. I used a mechanical marking tool to mark them for myself. They came well oiled in plastic boxes. They all will work for what i need them for.Although they are new. If they are supposed to be the same length most likely that is why the size did not engrave correctly. I would recommend they advertise them as blemished (markings). My opinion.

Collets are made well and work great, a good deal for the money

All the collets are the right size, have low runout and engage in the taper correctly.However, you need to check the thread depth to make sure your drawbar will pull them tight.I needed to chase the threads down about 1/4 inch deeper to get proper holding.The other solution would have been to pull the drawbar out and add a 1/4 inch thick spacer.

I did not get the 5/16 collets in my order! I did get get a 10mm collet that does me no good.. James

Not perfect but good enough for my mini mill and better than a drill chuck for end mills :-)

Bought this kit after sending another one back because this kit has a huge variety. I've never had a bit or tool that doesn't fit in one of these. These were nicely packaged and labeled making them easy to work with. Very happy with them

Came in time given. Individually packaged. Already oiled. Have used just a few times and works as described so far. Not sure about long term, but short term has been good.

Good enough for my use