🔗 Connect with Confidence!
The DERNORD Stainless Steel 1/2" Hose Barb x 1/2" NPT Male fitting pack includes two durable, corrosion-resistant fittings designed for seamless connections in home brewing and plumbing applications. With a temperature range of -30 to +150 degrees F and a maximum working pressure of 150 psi, these fittings are engineered for reliability and performance.
P**E
wrong size barb for 1" black ABS pipe
Couldn't use these as planned for the installation of my new well pump. Typically, when installing a barb fitting into ABS pipe I warm the pipe end with a heat gun because the fit is tight and makes the installation easier. These fittings dropped into the pipe with approximately 1/16" to spare. Impossible to tighten enough to make a leak proof seal. 30 mile round trip to Home Depot to get a barb fitting which actually fits 1" ABS. I am not sure exactly what size pipe/tubing these are supposed to fit, but definitely did not fit standard 1" ABS.
J**7
1” Hose Barb End Grossly Undersized
Very well made, but hose barb is much too small for 1” poly tubing. I have other 1” hose barb fittings that measure 1.075” OD. They accept poly hose with a bit of heating and seal thoroughly. This fitting has the hose barb OD measuring .980”.No amount of heat and clamping will seal against household well pump pressure (55psi).NPT threads were perfect.
D**S
junk
not a tight fit for the hose i needed to connect to it. Purchased a different one nearby and it fit just fine. Would not recommend you buy this fitting.
J**N
not 1" barb, more like 7/8"
needed a 3/4NPT to 1" barb for my 1" PVC water line to 3/4" filter housing, the threaded side worked great, the barb was loose and hose clamps would not tighten enough. barb was too big for 3/4" hose, and too small for 1" hose, no idea what it's intended for, but it's not for a 1" pipe
E**T
Not 1 inch
not 1 inch a little under sized, to the point its too much to expect the clamp to hold it
R**U
OD too small for water pipes
Do not buy this product if you are going to use it on well water pipes as the diameter is too small
R**.
CAUTION! 1" barb is too small for 1" pvc water line.
The 1" npt to 1" barb looks nice but beware, the barb side is too small to fit into a standard PVC plastic water line. There is about 1/16" of clearance between the barb and the hose. I was not able to make it seal. I'm returning them as they are useless to me. I ended up going to a hardware store and getting galvanized ones that worked correctly to finish my project.
K**R
Does not fit pipe
This is written as working with multiple applications. This does not fit 1" pipe and will blow off if under pressure greater than 25 psi. It leaks at 15psi or greater no matter how much you tighten your clamps. It is just a little small.
D**C
Cheaply made in china
The finish is not good, this is not a quality Item. Machining is rought on the thread and the 1/4 bard is a bit small for a snug fit.I returned it.Oh , yeah it's made in china...
Trustpilot
2 days ago
5 days ago