RULLINE 2 inch Hardware Exhaust Clamp, Lap Joint+Bolts Band Flanges Clamp Stainless Steel Universal Compatible with Muffler Downpipe Catback Pipe Connector

Great quality product. 2” inside diameter as described. Buying another just for a spare

Oem fit.

Body is good, bolts and nuts are low quality and bolts are bit short. Not bad for a quick temporary fix, but don't expect it to last long.

I used these to repair a set of y pipe flanges on an old Grand Marquis. And for that job theyre perfect. They hold the pipes on place and have enough structure and strength to hold everything firmly in place. That said none of the bolts snapped off, but they felt a little weak.

Perfect fit for the connection between the cat converter and the rear exhaust in my stock 2004 Audi Allroad 2.7T

Note that this is for a 2" ID (inside diameter pipe) NOT a 2"OD pipe (which is what I searched for).Most clamps are sold by the OD size (it is hard to measure ID when the parts are assembled, and you need a replacement)!I was able to make it work with longer bolts I had on hand, and saved the old sleeves which I can clean and reuse. I think I will need to get better bolts and use these clamps with the old sleeves. These sleeves might not seal as well over time on the slightly bigger pipes.It would be nice if the product info included allowed you to pick other sizes, because they seem to be well made clamps.

Wow! This was better than the other clamp I used earlier. The other one that I used slipped off after a few weeks because the two pipes had a 1/16 or 1/8” difference in diameter. The replacement muffler had a 2” diameter but the original exhaust pipe was a tiny bit smaller!This clamp is longer in length by an extra 3/4” so that was good. There was a 1/2“ or so of a gap between the pipes (it was a poor estimation cut on my part). But to make sure the clamp doesn’t move I’ve installed hose clamps between the clamp for reinforcement.This was way easier to install because I didn’t have to manually compress the clamp. The other clamp needed 3 hands to install.Anyways, it cost a few bucks more but after my experience with the previous clamp, it was well worth it!!! Highly recommended.

In the picture the clamp is on 2" OD pipe. As you can see there is huge gap between the clamp ends, which would allow exhaust leaks. The bolts and the 2 outer 1" clamps are not stainless steel. Also the bolts are too tiny and would definitely snap if you try to tighten them to the end. This is going back. Do not buy.