Rannb 長方形ケーブルグロメットメタルワイヤー穴カバー コンピューターデスクワイヤー管理用 ブラック 160mm x 80mm - 2個パック

These worked great to create wire holes for my desk so I could run my cables underneath my desk...and I had a lot of cables! These make my messy desk look clean again!

They are well built

Bought this product for an install into a stage. Well made and sturdy and the flap is just great. Amazing result at the end.

These work exactly as expected! I built this setup from scratch, but you could easily add these to and desk/gaming station. I built a box underneath with a hinged door, then ran wires to pc... just look at the pictures, they explain the whole thing. Highly recommend!

The idea behind the product is great but there are a few things that I think could be addressed to make it a better product. I didn't get this to put through a table/desk top but instead put it in the wall so I could get 16 ethernet cables installed in a new server rack. The normal brush plates are too small to accommodate so many cables and I didn't want to install multiple plates either. The rectangular grommet looks real nice, generally has a good "feel" to it and works well for my purpose and wasn't expensive. The two issues that I have with it is: 1. The nylon bristles are not stiff enough to hold a cable in place. I believe it's due to the bristles being longer than you'd typically see on brush plates and that there are no bristles on the other side to help give support. As it is today, I would not use it since it wouldn't hold even one cable (vertically or horizontally) in place. 2. The quality control was not as good as it should be. The grommets were not exactly square or level and the hinged panel on one of them was installed lower on one side and noticeable. Every screw except the 2 silver ones on both grommets were stripped severely during manufacturing. Most people probably wouldn't care that the screws were stripped because they wouldn't think to take them apart but I sacrificed one of the grommets (RIP little grommet) to take it's bristles/brush and installed it in the other grommet on the opposite side of the existing bristles. This way I now had the support I needed to hold cables in place. The screws being stripped at the plant made this a lot more difficult and didn't help me any with trying to not bend it any further. If the seller/manufacturer added the other side of bristles and pushed for better QC then I think it would be a 5 star product easily.