Rhino 4200 Label Maker Heat Shrink Tube Aonomi 18051 a18051 Replace for DYMO 18051 1/4" 6mm Heat Shrink Labels Compatible with DYMO Industrial Label Maker 4200, 5200, 5000, 6000, Black on White,4-Pack

Using these w/ Rhino 4200. They fit well, print well and shrink well. Solid product.

Exactly what I was looking for.

Overall, I have not been disappointed with with the Aonomi labels or heat shrink tubes. So, begs the question, when is good, good enough. For me, when value meets your needs without compromise. Highly recommended.

I purchased this 1/4" size to use on 14ga automotive wire because I use 1/4" regular heat shrink on it. It barely slides on the wire before heat shrinking. I had to order 3/8 to use on the 14ga this 1/4 is way too small.

I just finished using several of these cartridges for rewiring/upgrading our HOA Clubhouse sound and IT systems. I generated the labels using a Dymo Rhino 4200 labeler(another 5 start review to follow). Having retired I don't have access to my former employer's Brady labelers. The product is excellent and far more economical than Dymo's equivalent product. The Brady equivalent is even more expensive. Lettering is sharp and durable.If you haven't used heat-shrink wire labels before try shrinking them by heating on the opposite side of the lettering. Then tighten in up if needed on the letter side. This will make a tight wrinkle free label every time unless the label was too big to begin with. 1/2" works perfectly on standard CAT5 cable. With some of the thicker shielded CAT6's and above you might want to go to 3/4". Shrink wrap labels 1" and below will not fit over any connector.

When wiring controls and you have 50 red wires this is a must. I only wish I bought an assortment of different sizes.

I use the Rhino 5200 in the field for work and purchased the Dymo 3/8" heat shrink tube cartridge. The print turned out fine but the on board cutter would not cut the tubing. I had to waste excess tubing just so I could manually cut with my knife. I went to reorder more cartridges and came across this 4-pack for the same price as one Dymo cartridge when it's on sale. I thought for $25 let's give it a shot. Man was I impressed! The print turns out nice and sharp and best of all it is soft and the on board cutter cuts clean through with no issues! It also shrinks just fine when a heat gun is applied. Highly recommend and I will be stocking up.

I bought these for a project I was working on. Really did not have high expectations, I just hoped they would feed and print on my label printer.After a test print I was pleased to find better print quality 5hen the actual dymo labels. Labels shrank down nicely and left me a very clean looking labels.I will.be buying this product again.