Memory RAM Cooling Fans,5v/3-Pin ARGB Light Effect Memory Cooler for DIY PC Gaming. (White)

This is a nice addition for my pc. I dont mind rgb but i wanted an "extra" ventilation source, you know, just in case. Its cheap but its worth it if you wanna have an extra fan. The rgb is nice and bright.

With four DDR4 RAM sticks, the temperature is now 2-3F warmer than at room temperature. Without the cooler, the RAM was too hot to touch. The device is simple to install, and the fans are robust and high-quality. I don't hear any noise. The 4-pin connection has a built-in splitter, so you can also connect a case fan at the same time.

I've built a dozen computers over the years and I've never actually felt the need to provide cooling to the RAM components. But.... it couldn't hurt and it adds a little flare to look of your build.This particular cooler surprised me. I was expecting the fans to be held in a plastic chassis but the entire thing is actually metal and fantastic quality. It still flexes enough to wrap itself around the RAM channel latches. However, check your MOBO for enough clearance. My Strix z-790 has m.2 drive heatsinks that block the clip from getting under the latches.

This fan has a number of issues. Some of them I'm not sure if it is the fans fault. first of all the included photo instructions were useless as the plugs were marked wrong. The fan sits far to high off the memory to really do anything. the rgb is nice but i didn't use it as my case is solid so it wouldn't be seen. The fan speed is lacking at max you cannot feel air moving. I'm leaving it installed in the hopes that it is working with the case sealed. I would have liked to see a heat sink or something that toughed the memory shields to draw heat more efficiently. I would suggest looking for a better one

It's okay. Pretty much a "meh" acessory. A little attention to detail would make this a nice accessory. A lower profile for better air distribution with better mounting clips to improve stability would make this a winner.

It was able to sync up to my other rgb items really well. Basically plug and play. I like that you're able to daisy chain off of the wire so it doesn't take up a fan or rgb slot.

Looks good in a PC that doesn't have RGB on the RAM, especially when that RAM runs a little hot due to overclocking. The fans don't add hardly any noise and drops the temps a few degrees.

It's worth it with how cheap it is... Think I just got a lemon

As far as I'm concerned, RAM thermals don't reach a point where it requires active cooling.However, for those who might overclock a bit or want to add some extra RGB to their setup, this might be for you.You just need to figure out how to hide the power cable somehow.

Works good

Item: ITleads Memory RAM Cooling Fans,5v/3-Pin ARGB Light Effect Memory Cooler for DIY PC GamingThis is a DDR4 memory stick cooler with programmable RGB lighting.Installation is easy. Two cables are connected to your motherboard - one fan power cable that will daisy chain to the system fan header and one RGB cable that will connect to the motherboard ARGB header or daisy chain with existing ARGB lights. Once installed and connected, the two small fans provide a good amount of airflow over the memory sticks.The unit is easily placed over the memory sticks and clip over the memory retention arm. The metal body of the mount holds the fans a good distance above the memory stick, allowing it to fit a variety of different memory stick styles from plan chip and board modules to modules with large heatsinks.