for Flipper Zero Modification Module,2.4G Module Expansion Board Support NEF Sniffer/Mousejacker, CC1101 Module,Module Accessories WiFi Multiboard

A10 board with esp32- module and SD card slot. Works and well priced. I was worried when it came in an envelope without a protective box- but it works. The USB-C connector has full functionality and connects well to a pi and GPIO The RGB light is a 3 setting switch. It means nothing and only shows that the device is getting power. It could be less bright, or even a LED... Personal preference.

Works great

This this is fun, but as the wife of the present receiver, ahhhhh! It can drive me nuts lol. I knew that when I bought it, but wives, listen up!!! My husband is NEVER excited to open a gift. He not only was so excited we all came from the other room to see what it was he got so happy over, as someone with adhd and a husband with adhd, he keeps picking it up and loves it

Product worked as written Love it

Great

The GINTBN for Flipper Zero Modification Module offers versatile support for NEF Sniffer/Mousejacker, CC1101 Module, and WiFi Multiboard. The 2.4G Module Expansion Board enhances the functionality of the Flipper Zero, providing users with a range of module accessories for customization. Overall, this product seems to provide a comprehensive expansion capability for those looking to enhance their Flipper Zero experience.

I love it

I can’t get this recognized even after updating USB drivers. Sometimes, holding down both boot and reset while plugging into USB and through the entire process, it will erase, but then it errors out, never transferring the software. Hell on that thumb. esptool.py v4.1 Serial port COM3 Connecting... Chip is ESP32-S2R2 Features: WiFi, No Embedded Flash, Embedded PSRAM 2MB, ADC and temperature sensor calibration in BLK2 of efuse V2 Crystal is 40MHz MAC: 70:04:1d:fa:d2:d6 Uploading stub... Running stub... Stub running... Changing baud rate to 921600 Changed. Erasing region (may be slow depending on size)... Erase completed successfully in 0.4 seconds. Staying in bootloader. Update: the board is now recognized but still errors out: PermissionError(13, 'A device attached to the system is not functioning.', None, 31) any suggestions