Industrial Heavy Duty Bolt on 3/4" J Bolt Gate Hinge for Large Heavy Driveway Gates Up to 1100 Pounds, No Welding Lubricated Ball Bearing Hinge 2 Packs

I installed these gate hinges on my 18 foot 350 pound gate.They worked awesome. I can open my gate, pushing it with one finger.I would highly recommend these for your heavy gate.

So far, so good. I just installed this on a gate that weighs about 150 lbs. I needed something that swings both ways and durable. It was a little bit of a struggle to instal, but only because I installed them by myself. I would recommend two people install.These seem to be built well and sturdy.

Good quality hinges for the price. Pro tip: put a small amount of grease into the zerk fitting upon installation so the zerks don't seize up. Then when you actually need to grease them, they will accept grease well.For these hinges, plan for exactly 4" between the face of the hinge post and the nearest face of the gate frame. This leaves about 5/16" of threads and allows for adjustability. You could get away with 3.5" between each, perhaps less if you countersink/counterbore the gate frame, or switch to jam nuts instead of the provided nuts.I opted for 4" to allow for adjustability over time, and installed vertical wood pickets to close the hinge gap to the customer's desired gap. One last thing, be sure to check the hinges to ensure they are square. if not, just clamp them down and use a ~24" piece of pipe to bend them to 90 degrees. This is a common issue with affordable J hinges, luckily it is not a hard fix.

Just built 8x8’barn doors with fresh rough cut wood. Probably weighs 300 lbs. handles with ease can open door with 1 finger. Just make sure you have a 1 1/8” box wrench for the nuts

Very nice works perfectly absolutely just remember to grease the balls

Product Reviewed: Industrial Heavy Duty Bolt on 3/4" J Bolt Gate Hinge for Large Heavy Driveway Gates Up to 1100 Pounds for $50TL;DR; Solid design; no drainage; includes grease nipple; all steel construction.Overall impression: very solid, nice design. I love the support bracket. It has a ball bearing which offsets the J Bolt by 1/16” or so. That being said there’s no exit for the water which could be problematic. Grease nipple - excellent.Bracket:7” by 1.5”, ⅜” thick. With the cylinder 2 ⅜”Mounting holes are 7/16”. Solid but welds look rough. Poorly spray painted.J Bolts:5.5” thread, 7.5” long overall. ¾” thick. Solid, rough spray paint job. Nuts are smooth - threading is good. Requires a 1 ⅛” wrench.4.5 Stars – very industrial and good value if you need a Ball Bearing solution.How I review:Reviews start with 5 stars and I subtract points.- 0 for value but I try to provide guidance-0.5 to -3 for product not matching description e.g. stainless steel is actually plated steel-0.5 to -3 for product missing badly on executionI select products carefully so low (1-3 scores) are rare but detailed comments and critiques almost always are in the review. Most of my reviews come out 4-5 range.If possible I dismantle or destroy items to examine inner workings.

When the listing stated industrial, they meant it. I was expecting such good quality, but these really exceeded my initial expectations. I think they are going to stand up to the abuse that my Great Dane and kids will throw at gate and fence I’m about to put up. Great price point too. (About $50 for a set of 2). Would order again if needed.

Tough durable construction. Easy to install and worked seamlessly with the gate. Smooth opening and closing without any issues. I feel safer now that my gate is more durable.