High Density Polyethylene Sheets HDPE Plastic Sheet Board for DIY, Heavy Duty Industry, 1/4" Thick,Size 6" x 6", White Color

Wanted to cut some extensions for base plates on mags that are flush fit (Sig P365 X 12 rounders) so the mag protrudes from the magwell. This stuff worked great. Cut it, drilled it, scuffed it up, cleaned both surfaces, high strength epoxy and BOOM, mags insert and engage the mag release much easier now without being so thick that I have to worry about over insertion.

Worked as designed. Recommend purchase for the money

Picture shows 3 ... there is only 1 item at that price.

This arrived packaged well and worked for the use as needed. Reasonably priced but price for this material and gone up.

Just what I ordered

This piece of HDPE was true to spec, size wise. It had protective plastic on both sides and was not scratched from the factory. Two big pluses. Unfortunately, it had a nice bow in the middle, probably a good 1/2". Not even close to flat. If that is important to you, buy a thicker piece if you can, or find another material. I sort of expected this to be flat but it wasn't. Didn't matter too much for my intended application, thankfully.

I used this to make a replacement depth stop clamp for my 1980s craftsman drill press. The part is no longer available, so it used the original to trace the outline, cut it out and made a new one. It's been working fine for months. This material is a easy to work with and stronger than the original, brittle plastic part.

Solid piece of quality plastic. Used it to replace the door in a pull behind yard spreader. The previous design was steel and rusted out.