MeiZhi Garage Door Opener Remote,for LiftMaster Chamberlain Opener,Openers with Purple Yellow Green Orange Red Learn Button,893MAX 953EV/EVC, Security+ 2.0 Code,Keychain,4-Button

Easy to program. Works well

It was easy to connect to garage door opener, did not have any problems.

These work like a charm and the price is right, but the instructions that come with them do not contain any pairing instructions. The paring instructions are all back on this products page in the video. Make sure you come back to this page after you receive them and watch the video for your type of garage door opener... It will make paring them easy. (I never even noticed the video at the end of the pictures, so I had to email the supplier for instructions, they directed me back to this page to watch the video :) )

They have the incorrect instructions for the Liftmaster red/Orange button. Luckily I’ve boughten enough knock offs in my lifetime to know that most of them are produced by the same Chinese company. Most vendors buy it from them by the bulk & slap their own brand name on it. They all function the same excact way. Yet some vendors are terrible at reproducing the instructions. So even though I bought this remote from the cheapest vendor, I found the correct instructions from a different vendor selling the same copycat product for more money. Here I will reproduce the instructions in clearer English. Why the long story? So that you recognize this vendor pattern too from now on & benefit from cheaper purchases.So here is the answer:Step 1) on the Liftmaster- Close the garage door (not sure if closing the door is truly necessary, but I followed this instruction nonetheless). Next press the red button once, do not hold it down for more than a second (6 seconds erases every other controller in its memory). The light next to the red button will turn on & stay on for about 30 seconds. If you can’t see the light it’s likely because your not on a ladder with your face next to the button. Anyways, you have 30 seconds to complete step 2.Step 2) On the remote control- enter set up mode by pressing & holding buttons 2 & 3. The red light on the remote will blink several times & then finally turn off. Now press the button you wish to program 3 times. Then press any other button once, then the button you wanted to program once again. For example, if you wanted to program button 1 to your garage door then do this- press & hold buttons 2 & 3. The controller light will blink several times & then turn off. Let go of buttons 2 & 3. Now press button 1 three times, then press button 2 once, and finally press button 1 once. The garage door light will flash a couple times confirming your programming. You are done.Step 3) is optional- if now you want to program button 2 for a different garage door then do this- repeat steps 1 & 2 above. For example- press the red button on the 2nd Liftmaster. On the remote, press & hold buttons 2& 3 until the red light stops blinking. Now press button 2 three times, then press button 3, and finally press button 2 again. Your garage door light should blink confirming the programming wotked. You now have both garage doors programmed into buttons 1 & 2.I hope this helps someone out there.

It was a little difficult to understand the instructions at first, but once I figured it out, I was able to easily program the remotes. Word of warning, if you have other remotes, it does change the coding so you’ll have to reset that one too.