Hairpin Leg Protector Feet - Set of 8 - Black - New Tight Fit for 3/8" and 1/2" Metal Coffee Table Legs - Hairpin Leg Feet

I used these hairpin leg floor protectors on my cast iron skillet rack. The cast iron weighs quite a bit, and having this protectors on the front legs of the rack cause a minor incline which prevents the rack from tipping towards the pan handles so the skillets stay put.Could you imagine a cast iron rack giving way in the middle of the night and all the cast iron sliding down to the ceramic tile floor?I would have a heart attack because I would think someone was trying to break into the house! So, if you have a heavy duty wire rack for your cast iron skillets, and need a slight incline to keep them safe, these protectors might be what you are looking for!They are also inexpensive, shipping was super fast!

These fit the hairpin legs on my vintage MCM cube nightstands perfectly to prevent them from scratching up the hardwood floors. However, they do not clamp down tightly on the legs, but instead act as little platforms for them. If you're not moving the furniture piece around much, they're perfect. I did not have to add felt to the bottoms of these, they do allow a bit of sliding if needed.

The leg protectors worked great! Tight fit and good quality. The only reason I gave 4 stars is because I only received 5 protectors of an 8 pack.

These protectors are sturdy. They do not slip, they stay put.

While these do a decent job balancing and keeping the coffee table in place. Every once in a while someone pushes it back from the couch, and a doodad pops off and the dog eats it or the cat decides it her toy, then the dog eats it.Having the extras is needed. I anticipate I’ll buy more again in the future.

works well but vastly overpriced for several pieces of plastic.

I like that they stay on even when picking up and moving my keyboard. Great floor protection.

I had high hopes based on some of the newer reviews. These are a very hard plastic, so they do not give enough to be applied to the legs. Why on earth would each packet of 4 (useless) protectors come with 12 (yes, twelve) screws!? Total waste! The caps are going directly into the trash, the screws will go into my collection.The picture on the far right is the original rubber cap (top), the bottom is the hard plastic junk. They are the same size, it’s the material that makes it junk. Putting a screw into the cap to mount it would totally defeat the idea of protecting your floors!