Teyleten Robot GY- BNO085 AR VR IMU High Accuracy Nine-Axis 9DOF AHRS Sensor Module Better Than BNO080 BNO055

I used a Lonely Binary ESP32-S3 Wifi board to connect with this board the first time attempted it did not work. But when I placed both the ESP-32-S3 and the BNO085 on a breadboard and wired them with jumper wires it worked fine. I recommend using ChatGPT to get started it can show you how to wire the board and help writing the difficult code needed to deal with the 9 axis sensors and Magnetic compass. It is a very accurate chip.

Boards are junk. Won’t connect using any method while other bno085 connect to same esp32 perfectly. Return window closed. Stuck with these. DO NOT PURCHASE UNLESS YOU LIKE WASTING YOUR TIME

After receiving these in the mail I was a little skeptical at first but after testing them out these chips really do the job well and their legiimate! Definitely ordering more of these!

Worked flawlessly with the BNO08X libaray.Tested on a Raspi 0 2W with python

Overall product is good but still trying to figure out how to change i2c address

Does not seem to work in i2c on an ESP32. Won't even detect, Tested with a known good MPU9250 and had no issues, swapped to this and nothing. I even bought two of them to make sure i didn't get a dead unit and nothing.

Is in fact BNO085Used for SlimeVR

This Breakout board worked for a few weeks, soldered into a PCB interfacing with a Teensy 4.0. One day, without a change in wiring, or any accidental shorts, the sensor changed addresses from 0x4A to 0x4B. now, it only sends data for a few seconds after power on and then stops all together.