460 Pcs JST-XH 2.54mm Connector Kit, 2.54mm Male and Female 2/3/4/5/6 Pin Header Housing Connector Adapter Plug, JST-XH Terminal Wires Cables Socket Connectors Kit

They are what they are. Seems like decent quality, only time will tell. They fit where they are supposed to, and I can crimp wires securely so, they just work. You will need a crimping tool, don't forget to get one.

Quick shipping, exactly what I need to repair the control board on my pellet stove. though not a perfect mate, my has a latch on the side, not the front, it fits snuggly enough that I'm no worried about it falling off. I can always change the male plug if I have a problem . Pellet stove is a 2014 Quadrafire Mt Vernon AE with the board in the back on the bottom.

I used these to make several custom ribbon cables for my 3D printer's steppers and LEDs. I did a few practice crimps then made my cables with no problems.JST-XH is a very small connector so you need a crimper with thin dies. My IWS-3220M makes it easy. The second-largest slot (1.5mm) works best.I also tried it with my generic dupont crimp tool. The dies are thicker so the terminal is buried deep and it's hard to get everything lined up, but you can make it work if that's all you have. Just be patient and make sure the locking tab stays outside the die.

The tabs for crimping are too long if you try to crimp without a special crimping too. I assume with the proper tool the wire should stay in the crimped connection without soldering.

Arrived on time and as described