TWTADE KCD2 KCD4 one Hole Black Rocker Switch Panel Housing Holder Aluminum Rocker Toggle Switch Bracket with Screws for Boat Car Automotive RV etc H-K050-1K

I had a failed switch on a power seat and used 4 of these switches in its place. Very easy installation and wiring. Works perfect and was much less expensive than replacing the seat or switch!

Switch worked perfectly for my application, would definitely purchase again.

The media could not be loaded.  I needed a waterproof switch to install on my snowblower. This switch was incredibly easy to install, and it works as expected. I will be able to use my thick winter gloves and operate the switch in either direction. I am very happy with the switch, and I look forward to it lasting a long time.

Good product works great nice feature that it’s lighted howeverThe installation details are very limited no diagram except an incorrect photo showing which wires go to motor and which to power and it wasn’t clear that you had to cross to 2 short blue pigtails to get the reverse polarity to work properly…… But that said it worked great once installed and connected

Pre-wired made install very simple.Top quality. Great price.

Just installed and works perfect. Had to wire by description to get illumination only when switch on, black and red to motor. when I wired as in picture the switch still functioned as it should but was always lit. So I guess depends if you want lighted feature to indicate has power so can find in dark, or switch lit to indicate you have activated switch. I wanted the latter so I didn’t forget and leave it on. Used on an rv bed lift.

True measurements of the switch body for mounting hole is as follows:0.84" on the narrow side,1.29" across the long side including compression tab,1.075"across long side not including compression tabs.This switch could be pushed THROUGH a hole that is listed on this page that is 1.5"x1.1"This and many other switches have a bezel that covers the hole the switch fits into.The switch body size is the governing factor for a mounting hole, not the bezel size.The mounting hole should be greater than 0.84" on the short side and less than 1.29" on the long side.The compression tabs would not work in a 1/8" panel because they are not designed to grip a panel that thick.It appears the tabs are designed for a 1/16" to 3/32" thick panel.In my opinion , the hole should be about 0.88" x 1.25" and a 1/16" thick panel.This will allow for the compression tabs to hold the switch firmly when it is pressed into a plate.This is the size I will use for a FrontPanelExpress dotcom design for a mounting plate for 5 of these switches plus a momentary key switch.

Used this switch for a snowblower chute rotator setup, worked fine for the first season, fired it up this winter and it is no longer momentary, gets stuck on both directions. Will replace with a different brand.

Works good. Wiring is pretty easy with the included wiring.