Generic Pack of 2 Carbon Filters Compatible with Belling and Stoves Cooker Hood

Smooth seamless experience. Right product, on time and fit for purpose. Best price on Amazon.

These looked like really good quality and were delivered quickly. Unfortunately didn't fit my cooker hood. I had taken measurements but was a few mm out so no luck. Defo check which models it fits first, I hoped I would be lucky.Did manage to source the correct ones and they were £10 each so the price for these two are very good.

The Belling originals for their cooker hoods cost a fortune but these, or the one from espares or spares2go cost well under half the price and do the same job as far as i can tell. I bought these for the first time in April 2016 and on inspection they seem to weight the same as the Belling ones (about 185g) and will therefore soak up about 50g of oily yuck during their life. At this price you can justify changing them a little more often but probably never as often as Belling would advise you too. I do mine every 12-18 months rather than 3-6 as Belling suggest.I have also just bought some compatible types from espares so if you see nothing else add here from Sept 2016, assume these worked fine and buy them instead of orginals.Also, if you try to find your exact make/model listed in the 'this is what it fits list' and you cannot find it, take you old one off and measure it. If the two round surfaces are 190mm (larger) and 170mm (smaller) and the thickness is 38mm, then it should fit just fine but, before you commit, also check that the hole in yours (centre) looks like a wingnut, i.e, a circle with a matching protruding knob top and bottom. If it has, take the risk. My model Belling wasn't listed and these fit just fine using the advice given above. Good luck!

good product

They seem to be reasonably made and a good price, however they do not fit belling cookcentre 110 stainless hood, 2 small strips of decent Velcro does secure them in place if you can't be assed to return them.the above fix is more than adequate in my opinion.

Good value, fitted perfectly. The old ones did need to be changed. So will be reordering in 6 months.

Didn’t fit so had to use tywraps to fix to either side of motor. Should hopefully last as a working solution but will need a different approach next time.

I got these for the kitchen cooker hood, for the house I'm renting. Perhaps it was something the landlord didn't check before renting the place out. The previous one most of the mesh had worn away, the little black balls inside were mostly gone and it was just caked in grease. It's great value for a two pack and I had it replaced with the new one in less than a minute. I'll just have to see how long it lasts. 🙂

1 seul filtre dans le lot