Mabett Fog Lights Assemblies Compatible with Ford Bronco 2021-2026 2/4-Door, Daytime Running Lights for Bronco Accessories,Upgraded Fog Light Assembly

Great product and backed with super customer support. Very bright, makes my bronco headlights look like candles. Clean look easy install. Thanks Love them!!

I installed the lights easily. They didn't even need to be aimed. Their worth became very apparent during the last rainstorm that hit the northeast, when it was raining so much visibility was minimal. I have another set of fog lights on the bumper and they did nothing to illuminate the road. I switched to the Mabett yellow fog lights and was able to see easily. Very bright and made what could have been a dangerous trip safe. Excellent product.

Easy installation and worked well for 4 months but now one amber LED has failed. Replacement lights don’t appear to be readily available. Update: Mabbet kindly supplied a new set of lights that fixed the problem for a while but sadly these LED lights continue to fail. I have diagnosed the problem further and the fault lies with poorly manufactured LED circuits boards that are very susceptible to moisture. The o-ring seals on the lights are very small and allow moisture in. The LED lights, yellow or amber fail due to poor soldering. No easy path to replace individual LEDs making them useless long term.

Lights look great and installation was simple. One thing that bugs me is that one foglight is brighter than the other. Time will tell if the hold up..

I hope this message finds you well! I wanted to share some tips to make the installation of your new headlights a breeze, as the directions can be a bit tricky. Here’s a streamlined guide for you: 1. **Remove the 4 bolts** to slide the light through and secure it in place. 2. Refer to the provided photos for reference. 3. **Next, take out the screws** under the wheel well cover and remove it. 4. Laying on your back with a headlamp on your head , look straight up to find the connector above you attached to the headlight. 5. To disconnect it, you may find it tough to grab – so, use a long-handled flat-head screwdriver to gently pry the cap off the headlight. 🔧 6. **Plug the new light harness** into the back of the headlight. 7. Connect the other end into the harness, and the third connector into the new light. 8. For a neat finish, use the **zip ties provided** to secure everything. 9. Finally, reattach the screws into the wheel well cover, and you’re all done! 🎉 The You tube videos dont tell you to plug into the headlight they just grab the harness with no way of knowing where it came from. The first light took me about 20 minutes due to the confusing directions, but the second light was a quick 5-minute job! These lights are super bright and really elevate the look of your vehicle! 🚘✨

I think it would’ve been worth more 5*’s if the housing wasn’t plastic and was more metallic. Although I do feel the price point is fairly reasonable when you compare them to others. So far so go since installing. Installation was a bit of ease. It’s easier if you jack the sides to get to all of the clips and two bolts. I have a 22 OBX Sasquatch package with KO2 35’s. If that helps you. With the pins, it is extremely important not to push down when you’re unscrewing them. Hope that helps. I have gone through the car wash and a few hard rains. They still look new and so far no water inside. So that’s my side of the coin.

A little hesitant at first due to the price. But upon receiving this pair of fog lights, I'm relieved and very satisfied with the quality and fit of these lights. I especially like the waterproof cables and the substantial weight of the brackets and quality of the led lights. Installation was very straight forward and both the amber and white lights work perfectly with the two auxiliary switches I used on my Bronco.

These lights work great for the price and look ok on my bronco

Water got past the seals and condensation built up inside the lights themselves causing water damage.