Baomain 1-Pack 500A ANL Fuse Holder Kit with Fuse - Gold-Plated Terminals, for Car Audio, Amplifiers, 12V/24V DC Systems, Compatible with 0/2/4 AWG Wires

Used this as part of my Big 3 alternator upgrade

very easy to use and install. it seemed very well built i had no problem with it. very easy to see through to see the fuss.

I am quite pleased with this fuse holder. It barely holds my oversized 4/0 OFC wire

This fuse is installed on one of my solar power systems as added and necessary safety between my power distribution bus bar and my inverter. Usually a "Class T" fuse is used here, but I could not find a 120A Class T fuse. This is for a very small system and will work just fine.I love the all clear plastic fuse block and the large fuse window allowing you to easily see if the fuse is blown or not. The housing block and fuse are very sturdy and installation was a breeze taking just a couple of minutes.This fuse block adds necessary added safety to my system and is a great value for the price. I give this fuse block 5 stars for its design, quality and value.

Bought this ~6 years ago, installed it in my camper van and it still works as good as the day I got it.Highly recommend this!

Upgraded the Controller, solenoid, and switched to Lithium. This fuse block was just what I needed. I would buy this again if I needed one without hesitation.

I used this to wire up my sub in my truck and it’s been holding strong for years.

I do like the ANL better than the cylinder type. I have went through several cylinder type fuse holders. They keep cracking and falling apart. The last time, I had no idea what was going on. My amp would cut in and out until it finally died. I had 12 volts back to the amp so I assumed the amp died. I replaced the amp and the new one did not work. Again, I measured 12 volts. I started tracing the power wire to find that the gold fingers holding the fuse in place were breaking, barely making contact with the fuse. I replaced it with this ANL fuse and holder and my old amp came back to life.