DNA MOTORING WF-81019-MBK Factory Style Fender Wheel Flares Compatible with Dodge Dakota Crew Cab 2005-2011,Matte Black

So these took roughly an hour to install. Particularly because each little bolt in each hole took a while. But all you need is an 8mm wrench or socket, 13mm socket or wrench, and a stubby Phillips head screw driver and these slap right on. I had some fender well rust happening and without spending thousands on fixing it, I covered then up very cost effectively. Amazon is screwed up or I could attach a couple of pics

Correcto

Hard to put on because the don’t fit good. We got them on but still have a little gap. I would spend a little more and get better ones!

Good plastic will tell in the summer months, how it holds up. Rear fit perfect front is a little off, and over lays some of the headlight. All holes lined up except for the front one. Had to make my own hole to fit no big issue.

The rubber strip they give you to go against the bed doesn't stay on. Uses door edging instead. Once on it doesn't line up. Bout a 1/8" gap in front and 1/4" gag in back . Don't waste your time or money on these

I was really skeptical about ordering these because of the price. But I did anyway. Very pleased with them. Extra hardware so didn’t have to worry about getting more. Fastened right into existing mounting screw holes.

First off, no directions. If you know what you are doing, not a huge deal. Bigger issue is the screws that are meant for the outer part that secure them into the fender wells. They are WAY too short to do any good whatsoever. I had to buy M8 20 mm screws separately to get the front done. Go to the rear wheel, and due to there being an extra piece of sheet metal up in the rear bed, the 20 mm I bought are too short as well. So, I just had to order more M8 but this time 45 mm in order to get all the way through so I could attach the lock nuts. Very poorly put together as far as parts are concerned, coupled with lack of actual directions. You may want to look else where, save yourself the hassle of having to order additional parts to mount these.

Looks good, posting a pic so y’all with 4th gens can see what they look like.

I have purchased alot of these fender flairs for all kinds of different trucks. This set was by far the toughest to install. the rears were easy no problem. Fronts were a pain in the ass! Had to trim the flairs, heat them up with heat gun just to get them to fit inside the front door opening!! bad bad design. Good to you all that have never install fender flairs before. And to top it off these were the most expensive i have bought as well ! Never again…

they look great but some spots they stick out from the truck. and not enough adhesive had to spend more money to get them to sit right.

Was what we expected EXCEPT FOR no instruction and screw not included the couple of screws that were included were too small to be of any use. Think about buying this if you are not experienced in installing this product

I received this fender flare kit by DNA came with no instructions Also not enough hardware The nuts and bolts that go into the holes of the plastic was small the bolts couldn’t fit into the hole, but some could. Never came with enough metal tabs And now have to figure something out to try and mount this to the truck, I have managed to get the rubber liner on the edges of the fender flare This is a long process when you don’t have all the supply’s to install.

I was hesitant because of great price. but they fit great and easy to install. added new life to an old rusty truck. way better than spending money on body work with 400 k on the truck.