Junction Box, Zulkit Project Box IP65 Waterproof Outdoor Box ABS Plastic Electrical Boxes Electronic Enclosure Black 6.3 x 4.3 x 3.5 inch(160 x 110 x 90 mm)(Pack of 1)

used this to house a small ESP-based microcontroller and relay for a lighting project. gasket fits well and makes a solid seal. i drilled a hole to accommodate some wiring though and it was easy enough to drill with a standard bit. be aware the inner dimensions are not perfectly rectangular due to the screw holes in each corner. sturdy, solid construction.

I’m using these for outdoor work boxes for low voltage switches. The boxes are sealed and use a gasket under the front plate. The mounting holes are through the edge of the box and do not allow water in.All that’s necessary to mount switches and wire glands is a step bit.The box is well made and available in several different sizes. The only improvement to the design would be a slightly larger opening for the mounting holes. I needed to use special small head finishing screws to mount the boxes.

I'd take off 1/2 Star since you have to install the gasket and it isn't a continuous gasket, but the box is sturdy for being plastic, has stainless screws, and is offered at a decent price. I will buy more. I'm using one box to mount a buck converter, on/off switch, and 9vdc power jack with a battery converter mounted on top for a Milwaukee Fuel battery. It provides ample, clean power for guitar pedals. The batteries last many gigs before needing a recharge, it's easy to carry a spare battery and it eliminates searching for a 117vac outlet, ground loops and having another power cord on the stage. Use a daisy chain, plug and play, excellent clean power and far less expensive than the regulated, filtered power supplies they try to sell you. FYI, you can do the same with a DeWalt battery adapter, or any other. You'll need this box, the battery adapter (they come with on/off switches and fuses), a buck converter and a DC out jack. Tools; a drill and bits, screws to mount the battery adapter, a soldering iron with solder, and a multi-meter to set the buck converter voltage. Not difficult to do.

This case was perfect for my project. I had to machine it and it did well. The only drawback is the case finish is real smooth, so it shows marks and scratches easily. I decided to change it to more a matte finish by light circular polishing with a kitchen plastic scrub pad. It takes a little time to get it even, but it is better about scratches.

Perfect for an enclosure protecting a pair of alternator positive output shunt assemblies for maretron display input. Certainly not Bakelite but decent plastic grade a bit harder than the cheapo stuff . Possibly more brittle but still with good flexibility . Cut , drilled well and the price was extremely right.

Custome project box. Worked great.

Be Smart with a plastic project chassi, we don't want to toss it, preferred to repurpose or Recycle.Please do not waste such quality Project Chassi.

I used them as junction/cabling boxes for my outdoor security cams… but I can already think of a bunch of electronics projects I can build using these as cases. Good build quality, looks small enough but can pack a lot inside.

Made of good quality plastic. It does the job.

Le quite una estrella porque están muy caras, pero la calidad esta buena.

Lo usé para conexiones de acuario

Excelente contenedor para proyectos electrónicos, mis ensambles electrónicos tienen un aspecto profesional

Stainless screws in brass bushes, sealing strip easy to fit after carefully trimming to length. Robust plastic, suitable for use outdoors. Quite tricky to cut as it melts very easily; don't use an electric saw. Must be drilled slowly, too. Mine houses electronics on a motor-boat.