DNA Motoring TM-2JZGE-S Stainless Steel Turbo Manifold

This manifold will fit into the Mk3 Supra engine bay. The picture was taken shortly after installation of the DNA 2JZGE manifold. Since I already had the 2JZGE (Soon to be NA-T) in the bay I had loosen the passenger side (For LHD body) motor mount and tilted the motor to the driver's side so I could install the manifold. Tighten the bottom nuts FIRST then tighten the top nuts.Quality wise you're getting what you paid for and remember it's a $200 manifold. If you are doing a budget build and you need an inexpensive manifold this will fit the budget

You get what you pay for. This manifold in my opinion is crap, the welds are atrocious, the gaskets are trash, I really doubt you’ll get any decent flow or that the welds won’t break.

It's okay. Welds are so-so, and it came with a few burrs on the side, but for $200 it's honestly not bad.I wouldn't use a turbo bigger than 62mm though. That's what I'm running and it's almost touching the manifold.I haven't actually been able to test it because my car isn't finished yet, but I'll update once I do 👍