Orfit Orficast Easy-Form Splinting Material Heat-Activated Thermoplastic Tape For Trigger Finger, Thumb, Arthritis Pain Relief, Hand Support 1” x 9’, Blue, One Roll

New, in a sealed & wrapped package. This is an excellent product! It works better than all the other materials the occupational therapist has used to protect the joint and heal my mallet finger. The plastic splints for nighttime only use were not as effective at maintaining the exact position (without any slight flexion) like this casting material can, so the doctor wants to start another six-week protocol. She’s hoping to improve that last 15% droop.

So needed to cast a finger to hold it straight after surgery. Hot water from the tap was not working, close to boiling did the trick to start it to stick together. Careful not to burn skin so when touchable after dipping it in a cup of boiled water, then on a towl to dry some it wraped up and stuck together and hold it to harden like a molded cast. Wet and in the microwave worked as well but test 15 seconds, 30 burnt the skin so use caution. tweezers or that sort of thing. Wish it would stay pliable longer cooler. have to be careful.

You can easily make several finger casts out of this. It's even been useful for creative types of repairs. My doctor saw this and was amazed it was available on Amazon. I wish I'd found this stuff sooner it's the best

My PT was impressed I found this online, I couldn't get in to get a brace for an injury for weeks and I kept making it worse. I found this, made my own cast (you can even reheat it and hone your design) and it worked amazingly well! It hardens like a cast, but since there's no cotton inside you can get it wet. It takes a while to dry, but it still helped me a ton (I just made two braces so I could wash and air dry them in turns).

Cute and bright. Hard to keep closed, rip easily. Might do better with double sided tape.