2 Pack of 10x2.50 10" Inner Tube replacement for 10 Inch Electric Scooter fit 36v 48v 400w 500w 800w Hub Motor TR87 Angled Stem

it's been a couple of months and has been holding out good so far

Not good , 1 is ok but the other 1 is broken, its like you paying for 1 pcs.😔

I replaced my 10" innertube on my Hover-1, Alpha 1 scooter with this inner tube. It appears to have done the job successfully. I have 2 Hover-1 scooters and they appear to have the same inner tube failure issue. I will also replace the second one too. So far. I'm pleased with the results with the first replacement. It appears to be thicker than the original. It is holding the air. It took a little work to install it, but that is because to the Hover design, not the innertube. Be careful not to puncture the innertube when securing the tire to the rim. Getting the tire over the rim is not an easy task, so be care because you'll have to use some type of small crowbar to get the tire back on.

Quality is impressive and fits perfectly to Pure air Scooter. I have read some comments about the valve hitting the frame but it is wrong you just need to rotate the inner tube to the other side. The valve should lean to the rim. It will be a bit hard to attach the pump's hose to the valve but just bend it with a screwdriver then you can easily screw the pump's hose.

Good

Fixed my flat tire on my mobility scooter fine. Or rather the bike shop dude changed it for me. And ready for the next flat

Use these if you scooter valve comes out of the side as these won't snap on weak point ubwill go through 20 straights before U break 3 angled