Tactical Pistol Holster Rubber Grip Glove Sleeve for Glock 17 19 20 21 22 23 25 31 32 34 35 37 38 41

I highly recommend, this product fits a Glock 22 Gen 3 perfectly. I have big hands so the grip adds a better feeling and more control resulting in accurate hits on target. Very good quality for a affordable price, aswell it adds protection to the frame. 👍 Get it while you can, I will be getting more.

Well from my experience this is super useful, plus it’s surly a positive grip if you have to rely on speed, easy to install with the right patience. Buy a few I personally recommend if you go binary

Bought one for a Glock 17 Gen 5 and it fit so well I bought another for a Taurus G3. It fits the Glock perfectly and is very comfortable. The grip is easy to install and adjust and looks great. Thank you to the others that have said make sure the vertical striations are at the top. It’s just a bit large for the Taurus and I mean maybe a sixteenth of an inch in diameter but that’s just at the very top and doesn’t effect performance or aesthetics. It fits great especially considering it is being used on a pistol it isn't officially recommended for.

This sleeve was a little tricky to install because it was so tight. Thankfully, the material stretched easily so I was able put it on with a little effort (and a small flat head screwdriver). Other than the tricky installation, I can't say anything bad about the sleeve. It has a nice texture, fits securely and is a big improvement over the standard texture used by Glock. Note: My Glock has a 4mm backstrap installed. The sleeve will certainly be less snug on the standard/out-of-the-box grip.

I have a hand injury from years ago left me with some nerve damage these help with gripping and some recoil. I use them on all my Glocks

Bought it for my glock 19x and worried about the fit but it fits perfectly. good for any glock with a full size frame. the trick is to pull the sleeve onto the bottom, roll up the rubber then pull and push it up into place and smooth it all out.

Save your money cheap, throw away, plus they didn't fit, plus if they did fit it would have been thrown in trash

I have a large hand and the existing grip does not fit well in my hand. The idea of a grip flexible overlay is great however it is difficult to stretch out and over the existing grip and in my case the overlay tore while trying to install it. After dealing with the frustration, I trimmed the torn edges and reshaped the overlay grip to enable pulling it over the factory grip and added double-back tape to bind the loose edges to the underlying surface of the factory grip. I have used this McGiver configuration and find the larger grip fits my hand better and the tactile surface also improves the feel. With practice and better instructions, I am sure that a normal installation could be performed. One of the other wrap-around methods of grip enhancement would be much easier to install and would likely provide the same size and feel improvements for larger hands.

Tres cheap et le produit n'est pas confortable dans les mains