RLB-HILON Rear Sunroof Shade Handle Light Gray Compatible with Audi Q7 2007-2015 4L0898924B

Quick and easy to install. Perfect replacement to the broken Audi part.

I used this product on me 2015 Audi Q7. It was installed on the rear sunroof shade that was broken from the heat of the sun. This product was an exact replacement. It came with a tool to help replace the old handle and install the new locking handle.

Great fit for my car , easy to install

So heat finally broke the back roof window cover clasp on the 2013 Audi Q7. Replaced with this, worked on first try! Hard to get the screwes in, the hood will keep sliding back while you are trying to unscrew and rescrew with the supplied 90 deg torx wrench. Highly suggest leaving the screwes if you can, and just replacing the part, vs using the included screws. Once they are out, they are easy to loose in the hood plastic, and there is no easy way to screw them in. Get one started with the supplied tool, then get the other started while having something to prop open or tape open the hood to keep from sliding back. Once they are started, its easy to complete the tightening. Worked first try! Outstanding, would buy again from this seller.

I'm so glad I found this product. Audi was going to charge me ~$1000 to change this part because of the labor to take apart the entire assembly and replace it with an OEM part.1 star off because the base doesn't fit perfectly snug in the existing slot; there's a slight gap between the handle and the opening. I resolved this myself by taking out the the center component (the button that you press) out of handle's housing to replace the original handle.Also the color doesn't match perfectly, but it's close enough.

A little tricky to replace. Slow process since you can't put a lot of pressure on the screw due to the angle. Take your time and you'll get it done. A trick is to pop open the sunroof so there's a little extra room towards the back, then slide and hold the shade towards the back where you'll have more room for your fingers to get up in there to turn the screws.Also you'll have an easier time if you put the screws into the latch and remove them before actually installing the latch. This creates the initial screw grooves in the latch plastic so that you don't have to put as much pressure on the screw during the installation.

Would have been great with some minor instructions

This little part made the difference, it replaced perfectly the old broken one