Motor Controller, DROK PWM DC Motor Speed Controller 10-50V 60A High Power HHO RC Driver PWM Controller Module 12V 24V 48V 3000W Extension Cord with Switch

If you're in the market for an 60A speed controller, you'll quickly find three models of these controllers in the market.I've tried all three of them, and though others might have neat features such as an LED display of the percentage output, or a reverse button, this simple unit happens to dissipate the least amount of heat.I end up keeping this unit to drive my 40lb trolling motor which has a 50A draw.

I use it in my boat with a Minnkota 70 ft. lb. Edge trolling motor. Installed it in an electrical enclosure I found at Lowes. Added a small 24vdc fan to ensure I didn’t overheat it in a sealed box. Used two round electrical boxes meant for light fixtures to provide an intake and exhaust for the fan. Sealed the knockouts on the top of them and opened up the bottom knockouts. No water intrusion this way. Used Goop to seal up everything. Also used waterproof cable fittings to get the heavy wire into the enclosure.Used it hard for two days while fishing with no issues. It also does not cause interference to my fish finder whose transducer is installed on the trolling motor. The remote control is a great asset when navigating while trolling with several rods.Bill

I got this controller to run an automatically controlled variable speed cooling fan from my haltech ECU on my race car. It has no problem running a 16-inch fan that draws 40 amps, at any speed. In order to control the speed I had to purchase a solid state relay and drive the relay off of a pulsed ground that was provided by my ecu output because I could not generate a 5 volt pwm signal directly. But it does exactly what I wanted to do and it was extremely affordable. Zero motor noise at lower speeds. Zero current draw with switch off. Great product.

I was on my 3rd power-resistor defroster fan motor speed controller in my truck. The motor was drawing over 30 Amps and cooked the stock power resistor replacements in a week or two. The resistors would blister and crack open releasing insulating "sand" all over my truck carpet.I tried the power resistor setup with another (analog) speed controller - that lasted about 2-3 weeks before it smoked. The Amperage specs on that controller were "highly optimistic". The seller to his credit refunded my money.I decided to replace the analog controller with this controller. I figured a PWM controller like this one would deal with the high current and harsh environment better.I was right.I built a box for the circuit board and mounted it inside my dashboard and connected up the wires. I couldn't be happier. It doesn't even get warm at either low or high fan speeds. I have been using it daily for almost a year.Next step is to mount the speed-controller's potentiometer in my dash where the old fan speed knob used to fit.

I am using this to controller the AC/Heater blower motor on my 85 Chevy pick-up. A correct install can be a little difficult depending on the location of the control board and potentiometer . I located the board out under the hood close to the battery and the potentiometer inside at the AC controls . You need a 5 conductor wire form the board going to the pot inside truck. I used CAT5 cable. I used 10awg wire from the battery to the board. 10 awg from board to motor also. Works Awesome !!