Rubber Cutting Board Feet with Stainless Washer and Screws, 1.25 inch Black Round Rubber Feet, Non Slip Bumper Pads for Furniture, Electronics & Application,20 Pack

Good quality and good price

Bought these to replace the little feet on a chopping board when the originals broke off. Worked really well. Plenty in the pack.

In contrast to some negative reviews, I found the screws fit fine through the holes (they're neither loose nor oversized) and my PZ2 screwdriver bit was just the right size. However, they do strip if you use the wrong size. I think they're thick enough to split the wood, especially harder wood, like beechwood or bamboo (which technically isn't wood, I know) often used to make cutting boards, so I made a few 11mm deep holes using a 2.5 size drill. The feet do feel a little bit more plasticky than rubbery, but they have great grip on my induction stove, and decent grip on my wooden countertop - my board, weighing 1.8kg won't slide, unless I want it to slide. Overall, I'm satisfied but at this price for a couple of screws and a piece of rubber I would have expected everything to be perfect.

Great cutting board feet, will buy again.

Not bad at all

Really good little feet, I use them a lot for all sorts of items I make I’m on my second or third lot. Can highly recommend.

used on 3D prints (PLA/ABS) and they work a treat with M3 hex bolts + brass inserts (not supplied)

I find it very hard to believe this is 100% rubber as claimed. Very glossy.They are hard and slippery. Feels more like plastic.Doesn’t really work as I intended to use them as stability for a cutting board. The cutting board actually became more slippery with these feet then without.I will try to sand them down a bit, see if I can create a bit more rough surface.