KASTFORCE KF5007 4 Inch 100mm Vise Mount Metal Brake Bender Attachment Bending Max Capacity 14 Gauge 2mm Mild Steel 1/8" Aluminum

These work way better than I expected. It easily bends 16 guage 304 stainless. When you are done you can just toss them in a drawer.

I bought this to put a 90 deg bend into 1.5" wide, 10 gauge stainless steel, even though it's only rated for considerably thinner 14 gauge. I used a length of pipe to get better leverage on my vise handle but then it did the job easily. There was no damage whatever to this device.

It worked exactly as described. I only had 16 bends to make for a school project, and there was no deformation at all. I did however break my vise. I was using a cheater bar to bend the steel. Not in any way the fault of the product in this review. After replacing the vise with a larger 6” model, everything went smoothly.

I’m using these products to bend 1/8” diameter steel rods. I think that this might be beyond what the priduct is designed for but it is doing the job- with a little bit of accommodation. I am happy with the product. I recommend using it with a rotatable vise that is mounted vertically on a vertical bar that can be clamped to your bench. Rhis has been working well for me.

So far this little brake has worked amazingly well. I got it for a project where I needed to bend some 14g stainless steel and it handled it just fine despite it being the max rated material it can handle. Finish could be a bit better, but it's cast so I'm not complaining. Definitely worth the money for small fabrication jobs. Works way better than those folding brakes you get at harbor freight. Keep in mind since it's vice mounted it takes quite a bit of strength to bend thicker material. There's not a lot of leverage on a vice arm. But it is doable.

These are great for small jobs that don’t require a full sized press.

Bends metal nicely

This bender works great but it doesn’t fit the small vises you buy here on Amazon. You must have at least a 6 inch opening to make this work.

Very useful device, easy to use and well made the bigger the vise you have the more versatile the folder can be.

Does what it needs to do quite well however the magnet quality is terrible and it barely sticks to the vice jaws, falls off under its own weight.

今まで苦労して叩いて折り曲げていた鉄材がいとも簡単に曲げることができました。左右にぶれることもなくきれいに曲げることができたのは驚きです。何か月か前に購入を狙っていましたが欠品になりやすく今回手に入れられたのは幸いでした。

Have to say better than expected, they are what they are, good quality and they do the job

Not bad, magnets are a bit weedy but other than that good..