Gorilla Automotive 21133Bc Small Diameter Acorn Black 5 Lug Kit (12mm X 1.50 Thread Size) - Pack Of 20

Good quality. Will order more for my other cars for sure

Beautiful look and good quality they fit my focus st perfectly

Loved this lugs! Fits perfectly and looks gorgeous on my rims.

Take your time in ordering, read some reviews online, gather the technical details and do some measurements.

Ive been using this for 2 years now. I know my review is too late but it is the purpose of writing this. Ive never had any issues so far with these studs. The black coat finish gives the rims a beauty.

Excelente producto, tal cual la descripcion, muy buena calidad! Gracias!!

Fits exactly like my old lug nuts. They came in a bag with the adapter piece. I was a little worried that they would be scuffed up, but they are covered in a fine layer of some kind of grease. I bought aftermarket rims for my vehicle and my old lug nuts could only be removed with an impact wrench. Using these lugs allows me to use a regular tire iron because of the adapter that comes with them. They fit 3/4" and 13/16". Very good quality product. If my little cap that covers the lugs and wheel hub falls off or becomes cracked or damaged, I will have no problem with letting these lugs be visible. Can't rate the durability yet, because I just put them on today.

Exactly as described, used on BMW e60 5 Series with wide deep dish rims and slightly smaller lug holes requiring a slim longer nut and tool. These worked perfectly for my needs, I have purchased these before and used them on another car for over 9 years without issues, i hope to have the same luck with these. They were paired with extended stud conversion kit and are work perfectly. Highly recommend them to anybody, even if it is to replace your existing nuts

I bought these for a set of Work Meister S1 wheels and so far like them. The lugs are impressively small and have a snug fitting key adapter. I have used a number of lugs before and these are probably the smallest I have seen. The diameter of the the outside of the lug (with the key on) is no bigger than the diameter of the 60 degree lug seat. This means it should theoretically fit in even the tightest tolerance wheels. These are spline drive lugs, so a standard lug wrench won't get them off. This likely provides a small degree of security by itself, though for expensive wheels I would recommend a good set of locks. I picked up the Gorilla Automotive 71631NBC Acorn Black Chrome Wheel Locks (12mm x 1.50" Thread Size), Pack of 4 . The finish will likely hold up well over time. This is due to the nature of the finish itself and the fact that the key fits very precisely and will not slip across the splines. I find that one of the main reasons regular hex lugs get scratched is ill-fitting wrenches which slip and slide across the surface of the lug. You will get none of that with these lugs. The key for the lugs has a section for a 3/4" wrench and one for a 13/16" wrench. I would suggest using the 13/16" since it is closer to the middle of the key, and is a larger diameter. This will put less stress on the key itself, reducing wear over time. Overall a very well designed set of lugs for tuner wheels.

Fit my Nissan altima 2007, thankfully this time around I couldn't find any locally and this did the trick just don't lose the tool or else you'll have to order a new one from Gorilla. Not much else to say other than they are good quality and work.