Husqvarna 530069599 Fuel Return Line Kit Replacement for Small Engines

Works as advertised. Perfect fit!

Purchased this to go with a new carburetor and fuel filter, it has the fittings and everything worked like a charm. It has basic instructions on cutting the tube to a tip, but I didn't like the instruction for cutting everything to the same size. You're better off cutting one end to the sharp tip, and then inserting and pulling through to attach the fitting, adding another tube, and then adding the filter. Then back everything out. I did use a heat gun to soften the tube to make insertion easier.Should also purchase Hemostat clamps to act as curved needle-nose pliers to be able to grab the tubing after inserting into the tank.Long story short, watch a few youtube videos.

Needed to replace fuel lines on Husq 128 string trimmer. This set did the job perfectly. The only different is this tubing is more clear and a harder material than the original (original was yellowish and spongier). Would by again. If you are buying this for that same repair, look up a few Youtube videos and pay attention to the the set up on your current trimmer before taking it apart (length of lines specifically and where the pins go). Also, use a lubricant on the tubing. Makes the job much easier.

Kit has 2 sizes of fuel tubing, the smaller of the two is .08x.140 inch which is what the 142 requires for fuel line. Got my saw repaired.

Very easy to use Thanks!

Had problems with the line trimmer this year. This is the first time since I have owned this one. I can't complain after about six or seven years. I found the filter and the fuel line sitting in the bottom of the gas tank. When I got the fuel line out I gave it a little squeeze and it just fell apart. So I ordered this kit to fix the line trimmer rather then replace it. The fuel line replacement host came on time from Amazon. I replaced the fuel line pretty quickly. The hardest part was fishing the fuel line into the tank but after that it was a simple measure and cut. The line trimmer is now back up and running, hopefully for the next six or seven years but we will see. For me it is much more satisfying to fix your equipment your self rather then put it in a shop or replace it. I costs a lot less too. Hope you have the same success I did with this kit.

Just what I need to get my weed eater back up running the old lines were rotted out in the tank

This tubing fit perfectly and there was plenty of it to do the complete job