DPP TitaniumRed Dot Mount/Plate/Adapter Compatible with Springfield XD Trijicon RMR/SRO&Holosun 407C/507C/508T

I used this with a cheap red dot I had on my XD9 and it works well. I had to ream the mounting holes a hair on the red dot (think it was a 1/4" bit?). Anyway, the mount itself is nice and it comes with the anti-flicker sealing plate which I ended up needing. I did have to order #6-32 x 7/16" Flat Head Socket Cap Screws (monsterbolts.com) to use the anti-flicker plate as the longest screw that come with this were too short (if you have a genuine RMR this may not be a problem). I took it to the local gun shop to remove the rear sight since the XD is notoriously hard to remove ($20). The mount can be installed and removed easily with the set screws if needed. I put 100 rounds on it and so far so good. It held zero. Nice product. I'll update if I have any issues.Edit: I've had this for 6 months now and probably close to 1K rounds on it. The only issue I've had is there was a slight angle on the mount (you can see in the last pic) and the elevation was maxed so I added a 1.0 degree ADE shim and longer screws). This could just be the gun slide and/or red dot so YMMV. Otherwise a solid mount.

Fits my XDM 9mm perfectly and fits my Holosun 507c perfectly.I would recommend.

Mounted on my XD & my Holosun 507 C in just minutes. Works like a champ.

Item arrived earlier that expected and is exactly what I expected.

This tore up a sight alignment tool when I installed it. Hammer and punch finally did the job. Once on and centered, the fit for the Holoson 407C was perfect. Hitting the range tomorrow with it.

The mount appears to be solid. There's a .013 of an inch gap between the top of the slide and the bottom of the mount, if that bothers you, shim it. Zeroing was minimal on a cheap Cyelee micro reflex red dot, elevation was spot on and was slighter to the left. So far so good...

Does not fit XD-M Elite 4.5 10mm

Was skeptical dovetail would work but it’s solid.