14mm 12 Point 3/8-inch Drive Thin Wall Magnetic Spark Plug Socket for BMW, Mini Cooper, Nissan, Infiniti

Worked great for the MINI F57 plugs I just replaced, thin wall and strong magnet and a high quality finish. I was surprised because of some other reviews that showed a socket not as nice as the one I received, maybe they got a knockoff.

I bought this because I didn't have a 14mm spark plug socket and I needed to replace plugs in my wife's car. I like the magnetic spark plug sockets because they hold the plug without using the rubber insert. The problem with the rubber insert is that it gets oil and dirt on it and dries out over time. Eventually the rubber falls right out. (or sticks to a plug when you pull the socket out) I have even had the rubber part stick to a plug on the first use. (cheap sockets)The magnetic sockets are better but the downside is that small pieces of metal stick to the magnet. It is difficult to get the metal pieces out but it can be done. The best bet is to keep it in storage when not in use. (keep it away from the ground when you are cutting metal for example and keep it out of dirty toolboxes which tend to get metal filings or rust in them over time)There isn't a whole lot else to say about the socket. The sidewalls were relatively thin so it worked on the Altima. I now have one more size spark plug socket in my collection. One note on the iradium plugs though, don't drop them. They aren't meant to be gapped. Get the right gap plug when you buy it. I dropped an old plug after I was done and the gap was way off due to the drop. If I had dropped a new plug I would have had to buy a replacement.

Great experience!

Must have for mini Cooper spark plugs, worked great, would recommend.

Product worked wellA exact fit

For occasional, weekend repair use, it's fine. But it's a bit on the flimsy/thin side. It gets the job done - made plugs on a WRX easier.

This is exactly what I needed and it didn’t disappoint.

Not much to say: it does what it should. Magnet is just the right strength to hold on to the spark plug without dropping it or making it tough to remove

Exactly what was needed for a Mini Copper spark plug.

Perfect for my BMW N54 engine spark plugs. Magnet is strong enough to hold them on removal.

I used them last week for a 10th Gen Honda Civic and they worked. Had to spray a touch of penetrating oil and drive the car around to warm the plug up before they came out, but they came out and the magnet bit held the plugs in place when I lifted them out.

Perfect fit on bihex 14mm spark plugs. Magnetic and thin walled. Perfect for my Mini.

First time used today and does exactly what it says & does it well.