Round Belting PU Belt Polyurethane Round Belt for Drive Green 6mm x 10m

This allowed a lab at UTD to repair a diamond wire saw machine. This requires a soldering iron and razor blade or if you’re handy you can make an overkill designed fixture but it’s quite unnecessary. You practice welding it with short pieces and once you have done it a few times it’s quite good.

Take a utility knife blade (AKA box cutter blade) like ASIN B015W3AKDQ from Amazon. Clamp one end of the blade in a vice or vice-grip pliers (see picture) and heat the utility knife blade to red hot. Place one end of the length of belting against one side of the hot blade and the other end of the belting against the opposite side. Slide both ends of the belting off the hot blade so they touch and fuse. Hold for a minute or two until the joint cools and then carefully trim the joint.

I have a small motor that needed a fan belt and the belt was no longer available. This allowed me to make my own by cutting it to length, and then fusing the ends by running both ends over the opposite sides of a thin steel plate and fusing them together as they cleared the plate. I heated the plate using a propane torch until it was red, and no direct fire was needed for the fusion of the ends. It works fine and I have more than enough left over to replace it if it breaks as the original did.

Fabricated some pulley belts for a DIY wire/bobbin/inductor winding machine.

Used for Rick tumbler replacement belts. Great quality, easy to use. Just cut to the zize you need, met the ends and push them together. Rock tumbler has been going 30 days on this belt with no issues

I was a little nervous about "ease of welding" claim but it worked just fine. I was building a drum carder for my daughter.My setup:razor blade in vise gripsplywood with hole slightly bigger than beltmounted both in bench clampheated razor until red with torchpressed belt to both sides of razorput each side into plywood hole and pushed together for 1 mincut away plywoodTook me 3 tries to get it damn near perfect. Make sure the joint ends are perfectly 90 degrees.

This works super great for rock tumbler belts. Just be sure not to tight. Not enough give will destroy the roller bushings. Other then that I have been running one belt constant for over a month. I used a soldering iron with a flat tip to heat. Held each end of belt each side of tip then when started to melt i slid both ends together and held till cool. Be sure to get them even to keep the belt from jumping.

The media could not be loaded. I used this solid round plastic to make 7 new belts that drive a trumel that sifts dirt. This product is perfect for my needs. Highly recommend.