16AWG Quick Disconnect SAE Cable, 2FT - SAE to O Ring Terminal Harness Quick Connect/Disconnect Assembly, 10A Fuse

Not sure how much there is to say about these but I bought these for my Kawasaki Ninja 650 motorbike so I could easily connect a charger and they work / fit as expected. I bought this set specifically as I wanted the positive wire to be the one with the covered SAE end and not all of them I looked at were wired like this.You get 10 x 10A fuses with it. Not sure why you get so many but doesn't hurt to have a few spares! Although I swapped it for a 5A fuse as my charger isn't bigger than this anyway.Would happily purchase again.

Well put together, you get two leads for the price you normally pay for one!

Good ok bit expensive if anything

Just perfect right size in length and work brilliant on my electric 3 wheel scooter good fast delivery would definitely recommend

A safe waterproof plug & play solution for any RV or Gardern 12 volt solutionGood quality gear

After disappointed performance of a SOLAR trickle charger which failed to recharge the car 12V lead acid battery, I had to find alternative way to make it convenient to charge said battery. This battery is not under the bonnet but buried under 3 layers of false floor, small items tray and a wet muddy boots tray for it is located by the rear right wheel inside the car.Hit upon the idea to use SAE battery clips and O_Ring terminal harnessed cables plus a gender bender interconnector to run it from the depths of the boot of the car to above the tray such at I no longer have to empty the trunk of the car every time of charging. Problem solved.

Seem a bit pricey... Does the job

I connect these to my cars battery and place the SAE plug in an easy to reach place in the boot. No more stripping back and pulling out batteries to charge them.