4-Pack Aluminum Front & Rear Suspension A-Arms & Tie Bar Replacement of 2555 3631 2532 for Traxxas 1/10 Slash 2WD RC Car Upgrade Parts Hop Ups

This is a great product the only thing that caught me off guard was the big end of the arms that connect to the chassis of the Traxxas Rustler 2wd was not threaded. Lucky enough I have a tap die set to be able to make the thread (4mm tap set). That’s the only issue I have but other that it’s great and durable. I made it into a little STEM project for me and my son.

This fit my child’s Traxxas Slash 2wd very well. No figment issues. May have to adjust front wheel alignment. Just make sure to use blue threadlock on screws. So far after about 30 min of use it is holding up well. Not difficult to install. I think it will be much stronger than the factory plastic that came on it.

This kit had everything I needed and more. I broke my from suspension arm on a neighbor's trash can. oops!. I ordered this kit. I found the upper rods that have the E clips were both bent. This kit came with new replacements! wahoo! Working with the E clips was tricky. needle nose pliers helped with setting them on. BTW...Always use blue loctite and the screws won't back out as come have mentioned earlier. The original parts do not use it because the plastic holds them in. I'm back in business tearing up the neighbor's front yards while they're all at work.

They work ok there hinge pins are loose and have to much play on the front bulk head but they look great

had allot of sagging with the stock plastic ones, these kinda raised it up a bit, they run awesome on the truck, super easy to install!! I wish there was more color options for them. other then that 5 star all around!!!

Strong and durable just be sure to have a strong caster block

Front arms are way too tight. Had to sand down the ends and the bulkhead to get them to fit. Steering blocks end up being a tad loose and rattle around a bit. Rear arms and way too short. Won’t fit with stock control arms. Had to buy a pair of front control arms to replace the rear ones.

Great fit and finish, very easy install. Adds toughness to the truck for cold weather, as well as a slight suspension lift. Will be buying a second set for my son’s truck.