tesa51608 Black Fuzzy Fleece Interior Wire Loom Harness Tape for VW, Audi, Mercedes, BMW 19 mm X 15 meters

Great product! Used to tie fog light wiring inside the engine bay and used to stop rattles on the interior.Good stick, had difficulty taking it apart, annd was anble to restock the same piece multiple times. only issue is that it’s hard to cut but that just me using household scissors.

Works well for isolating plastic parts and pieces in a car interior to combat rattles.

It's the same exact tape that MB uses for their wiring harnesses. It's flexible and it'll smooth out if you are a little sloppy while wrapping wires up (you just press down those areas). Two things to note: 1) if you have to remove the tape after it's been on for some time, it will usually leave residue. But if you are planning on later removing the tape, you're probably not using harness tape anyway. 2) Don't use this in areas where you'll have higher heat levels. They make a specific kind for higher heat places, like the engine bay. The tape adheres very nicely and will not loosen over time or start to unravel. So for harness tape, this is the one.

It needs more sticking to surfaces but it is good!

Works as expected

My absolute favorite electrical tape. If I don't feel like using wire loom or if I just need to cover something up this is my absolute go to. Makes everything look OEM and adhesion is better than standard tape. Only downside is Tessa tape isn't necessarily known for its aging properties. It gets gooey and disgusting after 10 years or so. But hey, its 10 years. Just wrap tight and go around the ends a few times. Itll holdI only use this for interiors where wire can touch/rub on surfaces. If its not I will use the high temp version instead

This tape works great and is very close to matching the factory tape. I would recommend!

I bought this not for wiring harnesses, but for a barrier between plastic trim pieces on my truck to stop them from rattling. Works great. Adhesive seems quite strong, and the fiber itself is strong and resistant to tearing or ripping. I haven't had it long enough to see if the adhesive holds up long term, or with high heat yet...but I think it will based on initial impressions.