MaxTool 2-3/4" TCT Hole Saws 70mm Carbide Tipped Holesaw 2.25" Deep Cut for Cutting Asphalt Brick Concrete Gypsum Limestone Tile Wood MDF; CT00Y57R248

I used this to drill holes in plaster ceiling for a wafer light install. It drill effortlessly. Thank you.

Does a surprisingly good job of putting holes in brick. use lots of water, go slow, and no hammer function.

Did the job

I had some little hopes when it came to this bit, but I figure I tried it since it was cheaper than what I usually buy, if you drill just wood and there’s no nails you are good, but even tho it takes so time and strength to get a hole done. The teeth’s are so small that when you hit a nail, the bit is gone, good to use in 2x4 when with no nails nearby, otherwise don’t waste your money, besides that is a pain to get the chunks out, because the holes around the bit are not properly placed

Drills through plywood and nails with no problem

This is an excellent hole saw for fast rough in work. The carbide cutters cut like butter, the resulting hole is not the cleanest but if you are looking for a hole saw for rough in work I would recommend this one. I have only used this on pine 2X4s and plywood and was very satisfied with results.

Sawed through 3 coat stucco, lathe, building paper and 1/2” plywood and 3/4” rim board sheathing in 30 seconds….no problem.

Metal is too thin- as usual another cheap hunk of dung.