Rockford Fosgate P1T-S Punch 1" Tweeter Kit (Pair)

Bought these to replace a pair of Kicker tweeters that I got for $50 about 2 years ago. These were $10 more so I was really curious if they would be a better replacement.I installed one on the right side and left the Kicker tweeter on the left side to compare. Played some rap, rock and acoustical music and my attention kept turning towards the the Fosgate tweeter. It sounded more natural and clearer. Took the Kicker tweeter out and put the Fosgate tweeter in and was satisfied with the sound quality. I highly recommend these if you want something that sounds natural and clear. I used the -4db input on the crossover if anybody wants to know.

These are clear and sound good. Would recommend.

Wow, did these wake up my system!! I installed a full Rockford-Fosgate Punch amp/sub/speaker system and it sounded great. Only issue was the placement of the front stock speaker location....in the lower corner of the door panel. (2007 Monte Carlo SS) The system sounds great, but need a little extra to get the music off the floor. I installed these tweeters on the top of my dash, out by the windshield in the left and right corners. The driver side is on -2dB and the passenger side is at 0 dB. This did what they call "raise the floor" of the music. It sounds so much fuller, brighter and more enveloping. I actually had to adjust the head unit's equalizer flatter. But, wow, what an improvement to an already fabulous system. You will not be disappointed with these.

I replaced my factory A Pillar tweeters with this tweeter kit. After some easy mods it provides a decent upgrade to the factory ones.I read in an earlier review that these were more or less "plug and play"..that is not necessarily the case. The tweeter is too big to wedge into the factory hole, so you have to figure out how you want to mod it. Some people "bored" out the opening so they fit, I didn't want to alter the trim, so I made a bracket out of a cardboard piece from the box (I fastened a small piece of cardboard with the bracket screws from the factory bracket against the back of the speaker in the pillar). That worked like a charm and should keep it snug against the plastic.I tested the crossover db settings and I agree with the folks who set the db at -4db, this adds plenty of highs to the music. The other options are -2db and 0db.The kit comes with 2 pairs of leads that have bare wire on one end and female leads on the other (for factory wire and crossover) and 2 pairs of leads with female to male ends (for extending the speaker wire to the output on the crossover). These are great and a must have, at least in my vehicle.All said and done a little over an hour to install these for me. Some stupid bumps in the road like the pillar trim snap in piece getting stuck added to the time as well as figuring out what I was going to do about the bracket, but thats how it goes when you save some money...very happy

Awesome

For the cost, these are simply an awesome buy. I placed them in a newer F-150 that came with a stock sound system (which is pure garbage...all Chinese paper cone crap). I've ended up replacing/upgrading everything except the head unit which is touchy for the new F-150s due to the harness. Anyway, the tweeters in the A-Pillars were the last component and these got decent if not great reviews. For just over $50 though they looked to me like the right product at the right price intersection. Glad I bought them. Along with the rest of my system, I can now push the fade back toward the rear of the truck, crank the volume to allow the amp to drive some power into the speakers, dsp and sub, and the tweeters and center speaker are able to fill in the vocals very well with nice clarity and not-too-harsh highs. The crossovers allow for 0, -2 or -4db operation which provide some nice options depending on the system. I could've gone with the higher priced, higher rated and assuredly better sounding T1T-S tweeters, but they are 3 - 4 times the price. These are fine. Maybe someday I can justify the audiophile solution, but not today.

These tweeters are great for the price. I put these in my tweeter mounts in my jk wrangler to replace the stock ones. I did do a little modification so I would be able to use the Rockford grill and it looks great. Very sturdy and they also sound great. These are great for the price if you’re wanting to upgrade your old tweeters or even add some. You can’t go wrong with these. Feel free to comment and ask questions.

Got these to replace the horrible factory tweeters in the F150. Install was fairly easy and the crossovers are small enough to stuff in the empty space at the bottom of the A-pillar. These are 60 RMS and I don't have an amp on them and they sound amazing (had to adjust the treble down actually). The system will get a full upgrade with amps, but these will probably stay as part of the upgrade! 👍👍👍