APEXGEAR Tundra 3-Pin Sight .019" Black

I ordered this sight because I recently switched to the hindsight system after my peep sight popped off for the last time. I needed the bright pins and this sight delivered.Where it falls short though is the hair pulling experience of tuning it in. It has no lines along the slide bars to help mark the spot and when I try to move it 1/16th a inch I get the whole inch instead. Also when I torque it down to shoot after moving sideways the up down tuning gets thrown off. I thought about putting a touch of graphite on the slides but decided not to when the bow slid to the ground from a lean and the sight was knocked completely off where I had it. I figured if it slid that easy when torqued it didnt need help doing so.For the money you are getting what you pay for. If you have great patience and humility by all means buy it but I will be shopping smarter in order not to go through this again next time.

Fits well on my Diamond Infinite Edge and it fulfills its purpose by being a bow sight. A must have if you need an affordable bow sight for your bow with a level on it.

I've had this sight for about 2 weeks on my diamond infinite edge, and I have found several issues with it. The first is that it is a pain in the ass to adjust the sight because once you finally get the pin to where you want it, it often gets turned sideways when you tighten the Allen screw down. The pins are also cheap plastic and bend very easily. The level is also pretty much useless because it is extremely slow and the bubble does not move much. I would not recommend this for serious hunters, but it will get the job done for recreational shooters.

I got this sight stock on my diamond edge sb-1 in 2020. It's decent at the 10 and 20 yard line. At the 30 I dropped it as low as it can go and I hit 8inch below the target line. At this point I have to hit the sight and slightly flex my arrow shaft the clear the sight into the hostage. It's my first time shooting a compound bow and I know that this is all wrong. I had two range officers and a seasoned bow hunter helping me sight it in for 2 hours. It's good for 20yards at 40lb. I'll be buying a new sight before my second shoot. The bow is awesome the sight is trash.

Great if you don't mind readjusting the entire sight with every single shot. There are no markings to set your sights so good luck trying to be consistent in your setting. I took my knife and scratched a spot that seemed about right after trying to set it for the 246852157 time. It seemed to be the best-ish spot but there is 0 consistency as the entire sight moves after every shot. Sometimes a little. Some times a ton. It came on my Diamond Infinite Edge as a stock sight. My guess is because they couldn't give them away. Every single one of the bolts that hold the sight and settings in place are beyond flimsy and slide around after sneezing to hard and will not get tight enough to hold, so they will never stay in place. If I could give it zero stars I would.

You get what you pay for. The sight works...

I wouldn't recommend this sight. Very difficult to tune, it doesn't stay tuned for more than 5 shots. the cheap part's strip really easy. the pins are fairly bright but if you add a light, the green pin is the only one that works. Cheap plastic, but it gets the job done for the cost.

this sight came with my diamond infinite edge pro, it started off great, But when i noticed my arrows were drifting to the right, i adjusted the left and right , NOW its shooting WAY to high. once i fixed that... NOW its shooting to far left.... so basically you adjust it to the left... it shoots to high... you adjust it to go low... now its shooting to far to the right... lol. i think you guys get the point... its very cheap. if you adjust 1 thing. you end of having to adjust the whole dam thing again and again and again....