ANVISION 40mm x 10mm DC 12V Brushless Cooling Fan, Dual Ball Bearing, 2 Pin

I purchased this product to be able to replace the older fish style fan on my Young Living Raindrop oil diffuser. The fan spins a little bit faster than the old one but is still compatible with the circuit board within the product itself. It is also a little noisier due to the fact that it spins a little faster than the old style fan that was in the item.This was a better deal to buy it myself and replace it myself versus pay somebody for the exact replacement product here on Amazon to up charge me for the same product listed here.The diffuser works great it is a little noisier but that’s due to the little bit higher powered fanOverall great product I’m impressed and would definitely buy it again

Needed a small mountable cooling fan for a project and stumbled across these in my search. Bought one and liked it some much a bought a few more to have in my supply drawer for other projects. They're quiet and push a good amount of air for their size. Motor bearings seem to be good as I've used a few of these with no issues so far. They just work and work well. Good part, highly recommend.

Fan is nice and strong and very quiet. Works great. When I first installed this fan, the polarity of the old fan and plug was opposite of this new fan and it did not work. I contacted the seller and they said they test every fan before it ships, so they knew it was working at the time of shipment, and suggested I verify the polarity, and sure enough that was the issue. I swapped the wires and the Fan worked great.

Purchased this fan to replace the extruder cooling fan on a Creality Ender 3 Pro 3D Printer that completely died. I selected this fan because it has ball bearings, not sleeve bearings and because it comes equipped with JST-XH type 2.54mm 2 Pin female connector.To make the connection with the original wires back to the control board, I purchased a JST-XH type 2.54mm 2 Pin male connector (Amazon #B07YKHV46N) and 3/32" red & black 3:1 heat-shrink tubing (Amazon #B08KLSGKTG). A little soldering and heat gun action gave me the matching male connector in place. Reassembled everything without trouble.Fan works great though it does make a tiny high-pitched whine that the original Creality fan did not have so I subtracted 1 star. Still, since this fan is always on when the printer is on, I am hoping this fan lasts a long time with the improved bearings. Regardless, if this fan does not last longer, at least it will be easy to replace now that I have equipped the printer with the JST-XH type connector!

Noisy fan replacement, not as quiet as stated.My old fan failed and became very loud and noisy. This replacement worked but still loud and could be heard when it’s night time.

The stock fan on our 3d printer was so loud!.Replacing it with this fan has been awesome!

Well so far so good! Keeping frig from overheating under cabinets. Been installed for about 8 months

Installation on an Inovato support frame was a piece of cake. Fit right into the holder on the frame and plugged into the Inovato's spare USB port. The fan WAS noisy due to high RPM but did move a lot of air dropping the Inovato's CPU and graphics temps by about 10 degrees C. Last night, I noticed the fan was making some additional noise and this morning it was totally dead. The fan also had that burning/overheated electronics smell. Plugged the fan into another USB port and you can see the blade lock into a position but not rotate. Into the garbage can the fan goes.

Nice Product and Worked as intended

Der Lüfter arbeitet wirklich sehr leise. Er ist kaum hörbar und produziert einen ausreichenden Luftstrom.

bon silencieux

+++++av 5

Weak airflow, only 0.024A (0.58W) instead of 0.06A