PRO COMPSUS Pro Comp (63235) 2.25" Level Lift

3yrs on these and still good

My 2015i Tahoe Z71 looks fantastic with these. Only used the top strut spacers and it put it 1 3/4 higher up front. I'll add the lower spacers when I do the rear 1" lift. Went on well, took my time as this truck had less than 1k on the odo. Needed an alignment for sure. Really makes the Z71 look like it should, its not the mall cruser model and it looks much better with this.

This was super easy to install. The first side took a little longer and I needed some extra help getting the bottom spacer bolted in place, but the other side went smooth and problem less. This kit made my truck look so much better by getting rid of the stupid front end sag they come with from the factory. I would HIGHLY suggest to get it aligned after installation like the instructions say. My toe was out quite a bit according to the shop I took it too.

I called several shops and all of them told me there was no kit available for the 2015 Escalade. Amazon said this kit fit the 2015 Escalade so I decided to take the risk even though other people and the shop so I called told me that that kid wouldn't work. I decided to give it a try and it fit perfectly. The kit was very easy to install. The results where exactly what I was looking for.

I am giving this product a 4 star because the factory wire clips will not go back on after putting the supplied nuts on top of the strut. Other than the wires potentially flying around under the hood everything else went good on my 2015 Silverado 4wd.

I recently installed this on my wife's 2013 Tahoe. It took me about 1.5 hours on my own so it was super simple and I am by no means an experienced mechanic. A small amount of research and a couple of Youtube videos later, it was a simple project that anybody with a small amount of confidence can do on their own. Don't forget to get a front end alignment when you're done.

Installed this kit in a 2016 Silverado 2wd. Installation is fairly easy if you are mechanically inclined otherwise have a good shop do the job for you. Takes about an hour to install and completely leveled the front to match the rear of the truck.

It was easy as described. I did it myself in the garage on my Avalanche. 1:30 minutes to do both side. The first side took a little longer to make sure it was done correctly. The ride of the truck didn't change much if any. It makes the truck sit perfect for what i was looking for. I would recommend this to anyone looking.