Drive Shaft Tool Carbon Seal Tool OEM 529 036 026 RXP RXT GTX

Used it on my 2020 RXT X 300 and was a life saver. The part that is on the tool that you can adjust that’s butts up against the supercharger for my model the tool worked better just taking that off and finding a scrap piece of wood that you can wedge between the supercharger and the tool. It took about all my strength but after 20 minutes I finally got the hat to move back and got the c clip out. The tool was bending but never broke. Quality tool and definitely worth the money

Worked great on my 2018 RXTX 300. I did already have the supercharger removed though. It is pretty tight in there without removing it.

I bought this as I have two Seadoo GTXs and I needed to change out the wear rings. The hardest part of the process is pushing back the metal hat to remove or re-install the c clip. This tool is super easy to use, though like others have commented, the little post is installed backwards so I had to switch it. No big deal and I was expecting it due to reading other reviews. Tool is easy to use and provides enough force to push back the metal hat to get to the parts needed. It feels sturdy and I will likely use if for years to come. Simple design, easy to use; what's not to like about it?

This is the tool you need when removing the carbon seal/drive shaft from the Sea Doo. As mentioned by others, I lowered the rating to 3 stars for two reasons.1) The rubber piece placed over the screw is very thin and so when using it on a machine that has some rust from salt water it wears down and tears.2) The tool was put together reversed, so you have to remove the bolts and put it together properly. I do not anticipate that need when I purchase a new tool .

If you want to DIY replace the carbon seal on your Sea-Doo, you need this tool. If you enjoy cursing try replacing the carbon seal without this tool. But if you feel that cursing is overrated and would rather get the repair done quickly and efficiently this is the tool that you need.

turned a 3 hr job into a 10 minute job

Awesome worked perfectly frist time the Support ring was a little sticky but after a few times using tool it’s a. Very easy job about 30sec to get c cup of ,,,, cheers regards jason

Absolutely incredible tool we’re working on your Sea-Doo