ifloortapeDuraMark Foil Pavement Marking Tape, Reflective, Outdoors, Conforms to Rough or Smooth Asphalt & Concrete Surfaces (White, 2 Inches x 50 FT)

The tape is perfect. In fact, when it's tightly in place, it looks like it's been painted on.A previous reviewer had recommended using a rubber mallet to hammer it into place. I did that, and it was great advice!After using the mallet, the tape is pressed tightly over all the little imperfections in the cement.The reflectivity is excellent!

Clear reflective line. Adhesive is about the same strength of a post-it note. Could work well if you used with supplemental adhesive.

As others have stated/shown, my roll of tape was torn and jagged on the edges for first 10’. Luckily I didn’t need all 50’ yet. It’s a product defect issue as the packaging was perfect.

I use this tape for everything when I need a friction grip, like shovels, and for visibility and grip, like porch steps.

We just applied tape. Hoping it will last the entire summer

worked great for my pickleball court

To provide for social distancing at our HOA pool this summer, we grouped pool furniture groupings (stations) separated by an 8 foot distance. We used the foil tape to mark the edges of these furniture stations. The yellow tape is reflective and is very visible. We used a rubber mallet to pound the foil tape down onto the concrete pool deck surface. The tape adheres well and has not pulled up. We like this foil tape because we can remove the foil tape at the end of the swim season using a pressure washer and the concrete pool deck is untouched.

The tape is very good in appearance and ease of application.. It's easy to trim to size and shape. The plastic beads are highly reflective. The tape adheres well and lies flat at first. But I'm using it to stripe the slightly curved surface of a speed bump, and the tape tends to lose its adhesion to the asphalt under heavier loads such as truck or trailer tires. Under these loads the ends of the tape peel up and the surface gets puckered. The speed bump is new asphalt but has not been seal coated. The tape would probably adhere better to a sealed and less porous surface. So far I've gone through two rolls (one set of stripes is about 24 feet--I pulled up the first set and tried a second time), and I'm afraid in the end I'll have to do the paint job I was trying to avoid.