Flexible Sharp and Rough Edge Trim Protector, Push-in Edge Shield for Steel Panels, Wood Panels, Glass and Plastic Panels, Fits 0.07"-0.085" Thickness Edge, Black, White, 32'

Well made. Fairly soft so not a super strong grip, but for places not rubbed a lot it is perfect. I bought 4 and did 4 metal cabinet door frame metal edges and most of a large tool box. Very easy to put on and cut - light wieght enough to be cut on the metal without scratching the paint.

It will protect the edge of cut sheet metal, it conforms to all but the tightest curves. If you cut the "teeth" out, it will even go around a 90 degree corner. Stays in place pretty well, I ran a bead of gorilla glue around the inside edge after it was installed, and that has prevented any movement whatsoever. so simple, yet so effective...this is a great product for what it's indended for!

Nice and covers the sharp edges but doesn't look.all that great.

I use this at work to protect cables and hoses on industrial machinery. Particularly on cutouts in metal where the sharp edge could nick wiring insulation causing a short, or cut a hose line causing a leak. There's not always a right size grommet available and this product forms to any shape easily. I finally ordered some for a home project where I'm concealing cables through a steel tube. It was easy to cut to size and fit in the cutouts I made. It made pulling the cable easy without fear of damaging as well. As usual very reliable and easy to work with product.

I ordered this to put on the edge of some cut roofing material. It turned out to be too small. Good product but was to small for my application.

Nice snug fit on 0.045 inch thick sheet metal (as measured with paint). Used to protect wires from 2 inch diameter hole edges cut into the back of a metal TV stand. Black edge shield applied to holes cut into matte black painted sheet metal. Clean look. Edge shield stays put with friction fit only; no glue/adhesive used. So far no issues with pulling wires through the holes. I did have to use a file and sand paper to clean the edges of the holes I cut in the sheet metal as the small burrs left by the hole saw prevented the edge shield from being applied. After deburring the holes to a smooth-to-the-touch feeling, the edge shield was straight forward (albeit tedious) to apply.

If you bought this, you know what it's for. It is the real deal and works just like you'd expect.

I used this to line a hole in the roof of my Avion travel trailer where my 75 ohm coaxial passes through. I’ve worked at a major carrier for years, and always see this used in ribs where wire bundles pass through. The original hole was bare, the coax was sawed to the center conductor. So I shouldn’t have that issue again You can’t see the hole, but you can see the patch with the relief hammered into it so the cable is not pressed against the hole either. I also spiral wrapped the cable and everything was installed wet with SikaFlex.

Excellent product, speedy service

This worked very well. Pleased with the purchase. The best thing is to put it on the edge before cutting it. I was protecting cables through a hole I punched in a cabinet and I fit the edging first - and then cut it a bit larger and cut it to fit when I installed it.

Used to protect myself from a sharp edge.

good product