Cal-Van Tools 94800 Hub Puller , Zinc

I used this to remove the rear hubs on my 59 Willys wagon. It worked, but it required a nearly unbelievable amount of pounding with the hammer. I'm surprised (but pleased) that the tool withstood it.

This is an old school drum puller. Hit with bfh.

This is a solid constructed product. It tore the front pressed in piece of the hub off. I have nothing but great things to say about this. Go buy it!

I tried using heat and an old 3 arm puller and after a whole day of frustration I purchased this puller. Took about 5 minutes to assemble it and pull my hub off. I have owned many old Jeeps and had gotten by without it but now I wish I had bought one of these years ago. Price was good too.

Bought to remove the rear brake drums on my 70 vw bus it did take a little modification to the tool for it to open up enough to get on 3 wheel studs

More than a bit disappointed that it doesn't come with a plastic case, but it doesn't state that it does. Initial assembly of the legs onto the disc was super snug. This loosened up considerably once I used it, but that gives me some concern that using it spreads the ears of the legs where they connect to the disc. How many uses am I going to get out of it before it breaks? That being said, it worked perfectly (keep the screw greased) and I don't anticipate needing to use it much, if ever again. Viewed in that light, it is a screaming bargain compared to the next level up (Snap-On, Mac, Cornwell...).

Seems to be a good quality product, quality control needs checking though. I took one star off because there is a rivet that is supposed to go in the base of the hex drive to prevent the spinner handle from going past the hex into the threads. Either the hole for the rivit was drilled to deep or too large diameter so the rivet could not be installed tight and it was just laying loose in the box, I guess that makes it the consumer's responsibility to figure it out...which I will, but it should have been done at the factory. Still a solid unit I would recommend.

I wasted a lot of time attempting to remove the wheel hub from my Volvo. This tool made it easy. It's very heavy duty and had no problem removing my wheel hub.