Hantek HT25 Probe Inductive Capacitance Sensor Auto Ignition With Three Ends Test lead

Description

Auto ignition probe is a kind of inductive capacitance sensor, it must match with an oscilloscope. The loot line has three ends, a joint meet oscilloscope for BNC use, a clip for use, a clip grounding to pick high-voltage gleaned clip with. Features: Auto ignition probe is a kind of inductive capacitance sensor, it must match with an oscilloscope. Close to use, can be used to test a spark ignition secondary overlapping wave, overlapping wave parameters, thus achieved the detection, the diagnosis engine ignition position, make each cylinder ignition voltage changing with time directly from the oscilloscope display. The loot line has three ends, a joint meet oscilloscope for BNC use, a clip for use, a clip grounding to pick high-voltage gleaned clip with. Loot clincher over is a attenuator, used for loot high-pressure attenuation for low pressure, thus protecting oscilloscope not electrify impact. Specifications: When used please note: (1) Test clips shall not directly clip in spark plug, should be caught in the connection of the spark plugs of insulation wire, in order to prevent the breakdown and causing a shock. (2) To distance other high-voltage at least 2 inches apart, lest produce interference. (3) HT25 leading line length 2.5 meters, the decay of up to 10,000:1. Package Including: 1x Hantek HT25 Probe Review: Secondary ignition probe - This secondary ignition probe shows a good pattern if you have your settings right on your Oscilloscope. Review: Ground It Good - Item worked perfect to track down a misfire I had. Just moved lead to different spark plug wires till one waveform didn't match. Then I tested everything in that ignition. Landed up being a failing spark plug. I'm new to using oscilloscopes and it took a little while to figure out proper settings and triggers. You can see settings in picture. The very entry-level scope I had did the job with this probe. Great deal!