Toptiny Low Profile Flip Up Truck Bed Tonneau Cover Fits 2019-2026 Chevy/GMC Silverado/Sierra 5'8" Bed (69.6")

My truck doesn't have gooseneck/fifth wheel provision, but I might add one, later. Knowing the hitch will be behind the axle center on Silverado HD (centered on springs), I took one of the foam blocks from the packing material and placed it where a ball should go. The fourth picture is viewing the bed camera from inside, and I couldn't see it. If you don't have a bed camera, or you've got a spotter, or really used to pulling a gooseneck and can pretty much nail the hitch, it might not be an issue. That aside, it seems there's a quirk with the tonneau for 6'10" HD bed. The side rails are not one-piece; there's a long and short rail wrapped together. Thoughtfully, the left side had clear wrap, and the right, yellow wrap. There are stickers you can see in one of the pictures; the instructions don't mention this. And with that quirk of a two-piece rail and three clamps per side, I put one clamp on each rail piece at the extremes, and I bridged the joint with the middle clamp. It seems to work fine. Another thing worth noting is the foam strip at the front of the bed; ignore the instructions and put the strip on the back edge of the bed front. If you put it all the way forward, the fixed tonneau portion doesn't cover it. And it works fine with the Multiflex tailgate. I did it myself in about an hour. The initial placement of the tonneau and getting it to align with the catches was the worst, and I ended up going underneath to align stuff. But when I went to fold it out, everything just snicked into place. Really, it's a nice tonneau, and seems sturdy. And at the price, it's a deal. I think to make the most of a bed camera, it'd need to be a quad-fold, and that'd make it more costly. I'd give it 4.5 stars if possible, because it's so close to great.

I was a bit skeptical, but this thing fit great. I need to buy a tailgate seal as that is ONLY place water comes in during the car wash. This cover doesn't leak at all! Very impressed by the quality and durability. It doesn't rattle around or shift and fits flush and looks great.

The instructions recommended not going over 30mph when the cover is folded up with the props. Seems ok otherwise and I need the lockable bed. Edit; The latches that hold it 2/3rds open don't work very well and will need to be modified. That's ok because I'm not paying $600 more for the Bakflip MX4 to do the same thing.

It is a durable cover and the low profile is nice, however I’m not a big fan of the latching system. I struggle to be able to latch it

Great tunnel cover easy to install and great quality

pretty good quality

Very nice cover but one of the plastic corners came cracked, im waiting on a seller response to see if they can replaced it.

Nice for the price pretty solid would’ve been a five star review if that came with instructions!! fits nice