Balanced XLR Cable Male to Right Angle Female - 30 Feet Green - Pro 3-Pin Microphone Connector for Powered Speakers, Audio Interface or Mixer for Live Performance & Recording

I bought this for an older, side address condenser mic that has a yoke. The clearance between the yoke and the XLR jack is VERY tight and no other XLR plug that I tried would fit. This one does fit! Unfortunately, due to the orientation of the jack on my mic, this cable stuck out the front of the mic yoke. There are 2 small Philips screws holding this plug together. So by releasing the 2 screws you can disassemble the plug. I did this and was able to flip the orientation of the plug to make the cable come out of the back of the mic yoke. It’s not a difficult job, but a little fiddly. If you do this, go gently with twisting the wires around and make sure you have a DMM or some other means to test the continuity of the wires. Of course, test the continuity before you reassemble the plug because the last thing you want is to completely reassemble it then find out it doesn’t work because you broke a wire. You’d be smart to have a soldering iron and appropriate solder around to repair any wires you break too. Don’t fear. I was able to reverse the plug without breaking any wires. This cable is quite stout and high quality. I haven’t been able to test the sound quality yet, but I’m optimistic. If it sounds as good as it looks, I’ll probably buy a few more lengths and colors.

I’m a DJ and have a slanted case that holds my mixer on top and space for my amp underneath the mixer. I was keeping the amp and mixer connected with longer, 20’ xlr cables but these cables took up a lot of space in the case. I’ve been using these shorter xlr cables with the elbow connections and they work great. I’ve got more room in the back of the case for storage, my rig looks neater.

Got this for my Maono PM500 to cut down on the overall size and couldn't be happier. The sound is great, there is no additional noise from the cable, and the feel of the cable and ends is great. Plus it adds a nice pop of color if you are looking to add some. Would recommend.

Quality cable at a reasonable price. Connectors are sturdy and connect securely without any excess play or wiggle. This particular right-angle connector is much less bulky and clumsy than the more common rounded connector. Though I haven’t had to do this myself, the right angle connector can be disassembled in order to adjust teh angle that the cable comes off the connector when plugged into a microphone. Shielding is sturdy and color is vibrant. Don’t hesitate. Don’t second guess it. Just get it.

These mic cables get your cable out of the way, the feel and build is solid and the cable boots feel very good. The mic engagement clicks and holds a number of microphones very securely. I am very pleased with this purchase and went and purchased 3 additional cables due to their quality.

I have purchased 8 Coluber Cables. I like the cabling & colors. But three things: 1). the screws loosen up & I,ve lost quite a few screws, so I’ve used Locktite on the screws. 2). the white plastic strain relief inside & the black exterior collar’s thread strips, and 3). most concerning is the 90-degree xlr metal casing fit to amic loosens up to the point that the signal disconnects. I can’t have that during a show . I hate to report this negative review, but I find no warranty info for customer service either.

I needed a short right-angle to better fit my new mic (Heil PR30) on my mic arm (Rode PSA1). My regular cord stuck way out and felt like it was causing some sideways strain. This right-angle cable fit the bill and so far has worked flawlessly. XLR connectors are metal with rubber strain relief, and the cable is soft and pliable.

It's sturdy, it's heavy, and the right angle connector will save you space on your camera rig up.